talking about different alloys of lead

[@ArnoldHuggins-cj9vx]

Good setup ....are the holes drilled directly into the front of that device ,and if yes what size holes...you're giving me ideas and would have to get creative.

[@droberts6579]

Yes the holes are drilled directly down through the corner of the pot, I've been using this system for 40 years. The size hole for number 6 shot for instance is 30,000 of an inch. Number seven and a half shot is 26,000 of an inch. Step down about 2000s for every smaller size shot

[@ArnoldHuggins-cj9vx]

@@droberts6579 thanks alot...one size straight or start bigger and then the small drill bit.....im going to try make one as yrs i hahe 0.5mm bits would that work for a biger shot size

[@droberts6579]

@@ArnoldHuggins-cj9vx you can't go much bigger than number 6 size shot or it will just start to stream

[@Stuff_happens]

What is the coolant you are used NG? It looks like the type you use in machining.

[@droberts6579]

Yes it is, type B water soluble oil

[@Stuff_happens]

@@droberts6579 what happens if you don’t use coolant? Just water?

[@droberts6579]

@@Stuff_happens you can use water but it has to be heated to about 180°

[@superchat4065]

Hi I'm from India,can I buy your use dripper

[@droberts6579]

Sorry I don't export.

[@adrianphillips2552]

Don’t burn your fingers you can’t afford time off 😢

[@droberts6579]

I'm so skilled there is absolutely no risk involved. 😆

[@johnndavis7647]

Like being a blacksmith. Everything is hot. They don't wear gloves. They just get used to being careful.