TBOX - TORQ Servos Programming Card

[@DetoursRC]

Ordered one and some servos for my raw 420 build.

[@HelidirectRC]

Awesome!

[@andyMSH700]

nice video and very well explained....they are nice ...especially for something like wing servos for gliders which sometimes can be glued in there :) i like it.

[@jbenz63]

What battery are you using that has that plug end? This is not mentioned. Is this a specific battery i need to buy?

[@tonym995]

It’s just a standard receiver battery. 4.8volt 2000mAh NiMH is what I have but any that plug into a receiver will probably work.

[@jbenz63]

@tonym995 thank you, i called heli direct and Patrick hooked me up with the right one. 😁🚁🚁🚁🚁

[@EduardoJuarez-gf7vi]

Where can I find or purchase the servo guide?

[@katpis9121]

Need a question answered, I have the torq BLS 2208 and I just ordered the t box from you. Can I run 760us on my bls2208 also what do I now set the hz at in my spirit?

[@merrittpratt1600]

How do you reset your servo to factory?

[@jesussoto2663]

How can I troubleshoot the unit it is not working just beep after the unit it is power up. Both lights for the frequency blink red at the same time but doesn’t stop beeping. At first the unit worked but now it doesn’t. How can I troubleshoot it. I reset the unit plugged in different batteries and nothing. Please help!

[@mdemed]

I'm having the same issue. I haven't been able to use the programmer right out of the box. The unit just beeps continuously and the two red lights flash. I'm afraid its defective.

[@jesussoto2663]

Uuummm Wao I contact Helidirect and told me to use a 2s lipo 7.4 😳 I haven’t tested again been busy here with the Storm in Florida. Contact Helidirect to see what they say about it. Mine worked only once then it just beeps ☹️

[@mdemed]

@@jesussoto2663 Hope you're ok after that storm. Wow!. I was able to get it to work. In the video they show plugging the servo first and that did not work for me. I tried connecting the battery first, and it worked, and I am using a 2S power supply. What I did realize is after setting a servo is I need to push down on the servo neutral knob to reset the programmer. Good luck with the storm cleanp.up Also I found instructions for use on the rotorquest.com website. The Torq unit is identical to the KST version and that's where I read how to use it.

[@jesussoto2663]

@@mdemed Awesome I’ll take a look on that website all good where I live no damages thank God! Hey man thank you for all the info and your wishes!

[@HelidirectRC]

Are you hitting the enter button when you plug the battery in?

[@3dsmackdown]

Can it work with any other servos other than Torq?

[@HelidirectRC]

I don’t believe so, however you can truly it

[@atomicskull6405]

Possibly also with KST V6 and V8 servos (look up the KST programming box and you'll see why)

[@davidjacobs8558]

@@atomicskull6405 so... TORQ servos are just different branded KST ? which in turn is made by KingMax ?