HOW TO DRAW THE CAM PROFILE II KNIFE EDGE FOLLOWER II UNIFORM ACCELERATION AND RETARDATION MOTION

[@m.syedwahidali9691]

The following data relate to a cam profile in which the follower moves with uniform acceleration and deceleration during ascent and descent. Minimum radius of cam 25 mm, Roller diameter 7.5 mm, Lift = 28 mm, Offset of follower axis 12 mm towards right, Angle of ascent = 60°. Angle of descent = 90°, Angle of dwell between ascent and descent = 45°, Speed of the cam= 200 rpm Draw the profile of the cam and determine the maximum velocity and the uniform acceleration of the follower during the outstroke and the return stroke.

[@rohithivrale275]

Its very straight doubt to everyone , that how to divide 100 and 90 degree by same scale into 6 equal parts . Or either it taken approximately?

[@TECHCAD]

Dear In this video u have not explained that how to draw the displacement diagram. For that u can please see the complete playlist from my channel. All the best..... The complete playlist is at follows: kzbin.info/aero/PLhcTfWz-LJxNUtHMoVBlA8S00KHxrOhqU For Displacement Diagram pls follow the following link: kzbin.info/www/bejne/j2O4cmtpZbajns0

[@f0izan161]

sir why is( s )value 0.04 during outstroke and 0.05 during return stroke calculations why are the values different i thought it was only 0.04(40 mm) for everything

[@TECHCAD]

Dear u r correct... it was a clerical error only... Nice Interpretation..All the best

[@pushparaj3055]

How to divide equal parts in displacement diagram

[@TECHCAD]

Dear kindly check the following video link to understand the displacement diagram kzbin.info/www/bejne/j2O4cmtpZbajns0

[@hey_developer]

Thank you sir❤

[@HSardar-z5k]

Offset 15mm draw cheyyaledhu🙄

[@TECHCAD]

kzbin.info/www/bejne/Z6rEgaijq9N4lbM&pp=gAQBiAQB Se the above link....

[@m.syedwahidali9691]

sir can you post solving video on the above question please?? i want to know how to solve that problem.. please help me sir

[@SherwinJrOchea]

Sir please make a video for disk cam with oscillating flat face follower. Badly needed it 🙏😭

[@sandeepd7109]

Sir u didn't draw the offset circle

[@TECHCAD]

Sandeep the question is covered in two videos... check this link for offset follower part of the question.. kzbin.info/www/bejne/Z6rEgaijq9N4lbM

[@sandeepd7109]

@@TECHCAD tnq sir 🙏🙏

[@priyeshkhadpe6442]

Off-set circle not showing

[@TECHCAD]

Dear Kindly see the following link to understand the offset circle question.... kzbin.info/www/bejne/Z6rEgaijq9N4lbM&pp=gAQBiAQB

[@ManjitSingh-vw2qy]

How can I contact you?

[@TECHCAD]

dear u can contact at [e-mail]