TEKKNA AND ROMAN PART 11 SD 480p

[@Si_digs]

Brilliant 👍🏼

[@markallen8932]

Thank you

[@goldwax9795]

from wich program you make your roman program??, i want to try on my field.

[@markallen8932]

Sens full tones program 3. I only use two,programs gold field and Sens full tones custom which I name Roman , hope this helps I mention it in the video

[@markallen8932]

How did you get on

[@markallen8932]

Soil conditions play a big part, if they are wet ,moist, dry very dry, this will effect the machine, just a thumbs up , always carry some test pieces and check before you detect.

[@mmb2199]

Please put youre settings in writings ✍️ thank you:-)

[@markallen8932]

Sens full tones I will make slight adjustments in field depending what I want to do ,,,Sens 94 - 95. 5. Tones Silence 1 or 0. Iron vol. 0. Reactivity 0 to 1.5 high square tone ps , notch 23 -25 bottle caps off Will also run it in 3 tones descrim ,0 - 6.5

[@Si_digs]

Mark can you knock out coke and still get small gold or is there a trade off 🤔 ?

[@markallen8932]

I use 23-25 notch , on the test it found the thin bit of gold , problem with coke it can be higher than 25 , so using descrim will knock out gold , I don’t dig a lot of coke ,but I do work amongst the coke ,had a lovely mark anthony denarius

[@Si_digs]

@markallen8932 cheers mate 👍🏼 👌🏽

[@markallen8932]

@@Si_digs your welcome

[@JJ-no7fx]

Hi Mark,can you gif me the settings for the roman program?I have the 2.0 update.

[@JJ-no7fx]

What are the hz of the tone brakes

[@markallen8932]

They are on the video ,and I posted in comments , it’s based on program 3 , descrim 6.4. Sens. 94 this can be adjusted , audio response 3/4 reactivity 2 and lower for extra depth iron volume 0 ,high square tones, silencer 1 or 0 , i make slight adjustments one field , I always take a few coins with me and test ,due to different soil conditions ,and wet and dry soil makes a difference

[@markallen8932]

@@JJ-no7fx the setting are below in comments ,I use five tones ,but if the ground is cleaner will switch it too 3 tones

[@markallen8932]

Sens full tones I will make slight adjustments in field depending what I want to do ,,,Sens 94 - 95. 5. Tones Silence 1 or 0. Iron vol. 0. Reactivity 0 to 1.5 high square tone ps , notch 23 -25 bottle caps off Will also run it in 3 tones descrim ,0 - 6.5 1

[@JJ-no7fx]

Thanks!!👍

[@WilliamKanavan]

Hi Mark great the way you explain and use the XP the gold field your 2nd program are the settings the same except for IAR if different can you post Great job 👍

[@markallen8932]

It is different than gold field and quieter ,even though gold field is a fantastic program it’s very noisy and maybe part of that is because they use pitch , I use 3 tones if site is quite and 5 tones when busy , also audio response knock down to 3 and high square tones it applifies those signals , 1.5 reactivity soles 1 if ground allows , also if you want to get rid of most iron descrim 20 , I use this to cherry pick the targets , will do a depth test as before to see if I lose targets at depth , with descrim , sensativity max 94 you don’t gain depth just noisy machine ,silencer o ,iron 8 or 0 hope this helps, it is a deep program, it’s been tested by others against custom programs and comes out as one of the best ,this test was carried out by a person called Alan bouter, I think his from Netherlands

[@WilliamKanavan]

@@markallen8932 Thanks Mark for the comprehensive reply much appreciated the Deus is exceptional machine l primarily use in parks and on the beach and tweek as I go Thanks again and cheers from Aus

[@markallen8932]

@@WilliamKanavan your welcome ,happy hunting

[@Diddy291]

If you set silencer 1 or 0 if ground allowed D2 will go deeper. And for me if D2 are too chattering i tend to lower max frequency to 24 and maybe bit sensitivity.

[@markallen8932]

The silencer in Roman program is set to 0 or 1. What makes a big difference is the reactivity , when testing with 24 kHz and lower , on test fields made no difference , myths and facts deus 1 and deus 11. There are two of them as I did with wet conditions and then when I had surface water laying on the ground , dry conditions will normally give you less depth but can look at this in summer and do a video

[@waverider4510]

The thing about the D2 and all the programs, you adjust to suit conditions, you by dropping reactivitie and uping audio response does not make your program any better

[@markallen8932]

The programs have different algorithms, the video has been done live and no editing bits out ,so even if I say something in error I leave it on there , when carrying out the test just showing the facts , if you have a program you would like me to,try please let us know , was out today my friend with deus 1 and me with deus 2 , I set his machine at 32khz deep program custom ,he had 8 romans I had deus 11 Sens full tone custom ie Roman and had 10 I tried to use the tekkna program but struggled on the soil conditions I was on so switched it to my Roman ,

[@markallen8932]

Have to disagree , if the base program is missing the target , and custom program is hitting the target , that is an improvement , ground conditions play a big part , but video shows no adjustments while filming and custom program hits the target , many people using the program are having great success , if it helps people up their finds rate I’m happy