Tello Sensor error

How to Fix it

[@HJESUH]

Puede ser por el tipo de superficie de esa mesa, aunque sea plana. Pruebe a calibrarlo sobre otra superficie.

[@muhammadkhozin5698]

my drone also experienced the same thing as you. but how do you get it back to normal? I looked for references on KZbin to fix but didn't get it

[@dronepilot9548]

It getting normal suddenly.... just make sure battery fully charged

[@notconnected3815]

i did the calibration procedure as shown in the video (but i did not remove the propellers) now it works fine again i did not do the firmware update

[@aadarsharajranabhat9897]

My update is completed but it’s says only sensor error

[@SkyHubX]

im having this issue now and my drone just WONT start the calibration process, tried like 15 times

[@arnoldreciunas160]

Hi, my tello don't want to connect, so and write sensor error, what me doing?

[@Stallionriders]

seems your battery is bad, it stops working during the calibration. try the imu calibration with the charger plugged in.

[@dronepilot9548]

Good tq

[@dronepilot9548]

Plz comments below how to fix it tq

[@clintmaparecodo3557]

Do not update firmware. Make sure flat surface

[@barnabasonubi336]

Too late. I already updated firmware before seeing this. It just becomes very hot

[@gordpiper6496]

I'm having the exact same issue. Any cure?

[@dronepilot9548]

Make sure battery fully charged and cool the device with fan

[@davedawson687]

These drones are junk. I've had 2 of em and both of them are inoperable because of the sensors.