Teryx 4 800 How to Replace Rear Wheel Bearing Using Hydraulic Press And Access The Rear Axle If Need

[@larryfield5380]

Just bought a 2016 and fixin to do front and rear bearings. Nice job.

[@halo-vision6623]

It's not a hard job, especially if have a little press. If have any questions just holler. Thanks for watching...

[@larryfield5380]

Thanks. I have a 6 ton press being delivered tomorrow. Just figured out I have to change all the front bushings as well. Figured I my as well put a2" lift and heavy duty tie rods on while I'm at it.

[@halo-vision6623]

Bushings aren't to bad, just little slow if haven't done them before. 2" lift be simple since you'll have everything off anyhow. Lol I've not done tie rod change yet, I've aligned them twice though.

[@billboyd870]

Good job all the way!

[@Crawl_az_rc]

Do you not need to grease the bearings?

[@halo-vision6623]

It would be good to while have everything apart.

[@juanpontif7577]

I wouldn't. The bearing is machine pressed and grease in such a tight fit can have a hydraulic effect. You can grease the inside going inot the axle once it's pressed.

[@frankellet951]

Where can I buy the bearings?

[@LetsGoBrandon_]

cotter, not carter. 😉