Testing Input And Output Impedance - Simply Put

[@antonmilosevic]

Thank you Hagrid, very cool.

[@andreamodiano]

Thank you Hagrid, very essential and clear.

[@bravosixedan]

High quality content. Clear and straightforward.

[@davidrysdam902]

You said the magic words at 0:30. You want low output and high input impedance because that's a voltage divider. Crystal clear now.

[@briandoesuke243]

YEP!!!

[@heavymetalnewsdesk]

All these technical videos and me with ADD can't focus so i'm just scouring for an answer to my question, so I'll ask it here because you seem pretty smart. How can I measure the final output impedance of a tube audio amplifier? Not the output transformer, but the final impedance? Is this determined by the transformer?

[@baghdadiabdellatif1581]

Thank you 🙏

[@mouseminer2978]

Another great video. Thanks

[@billknight7442]

Great job, explaining !

[@Bigpaa]

Love the thumbnail pic for this vid! Lol

[@fredgarvin4482]

I wish he would have explained the connections between the meter and bread board and etc better. he went kind of fast for me.

[@buaidhnobas1ify]

Pat Quilter Jr.?

[@EnergySeeker]

can you show how to do the same using an VNA ?

[@ZonaALG]

Didnt know you existed...thanks for doing so!!! ;)

[@angelmoisesvalleanalco4503]

I have a problem at collegue when I try measuring current to obtain the experimental impedance of output and input of amplifiers (BJT's, MOSFET, Pair Darlington, Cascode, etc.). In many occasions this current is very small and my digital multimeter is not able to measure it. What can I do? Thank you so much. greetings from Mexico!

[@youupiiiyouupiii8235]

Thank you ! Excellent Video. Can we use RLC meter (in serial mode) to mesure output impedance when the device is off ?

[@kaybhee6]

are u in ca...

[@grandmastergyorogyoro532]

Me likes thumbnail. Likes.

[@minazulkhan8287]

can u help me in measuring impedance of my rf blood bank tube sealer ....how to measure and device to be used for measuring it

[@kaybhee6]

do u know of any one single dmm to measure watts directly ,,, or, va,,,etc for audio power amp testing

[@Spierdolony]

Excellent

[@kaybhee6]

keen

[@JacklapottTv]

Why do u say output impedance when in reality it's output resistance your in DC mode with that 5v I'm i right?

[@mike417]

You measure loading resistance not impedance

[@Sagarprajapatiajmer]

Pokémon lover

[@bennguyen1313]

I have pressure sensors that output a voltage (0-100mv DC), with an output impedance (990 ohm - 1010 ohm). For calibration, is there a way to simulate the sensor? I have a constant voltage/current source (0-100mv), but to simulate the output-impedance part, I assume it's not as simple as putting it through a 990-1010 ohm resistor.

[@naomiliu3015]

100mv through a 1k resistor should do the trick

[@chronobot2001]

Get a haircut... Just kidding. Great video.

[@Jnglfvr]

Ridiculous method. Set power supply to arbitrary voltage (say 1 - 4 v). Measure open circuit voltage. Attach power supply leads across 100 ohm pot. Dial down potentiometer until measured voltage is one half open circuit voltage. Remove pot and measure resistance. That is your output impedance. If you're dealing with an older power source (say an old function generator with higher output impedance) then start with a 1 K pot.

[@abraheom]

Thank you Hagrid, very cool.