TESTING TEMU DIES

[@EmmaFrusher]

Hi Sharon Great dies. I use a metal nail file to file away the small metal bits. The white core card contains a higher chalk content which can blunt cutting blades and dies quicker than coloured core card. Xx

[@littlebritco1337]

I didn’t know that Emma, thanks for the tip. I’ll keep the white core away from my dies from now on.

[@stephaniebaca9929]

Great video!❤

[@sheilag.3684]

I like your long videos! Snack and a drink are a must, but I also put projects together while watching. Tonight, it was putting pencil packs together. Thanks for the tutorial and test!!!!

[@littlebritco1337]

Thanks Sheila!!❤️❤️

[@edwardhandziak4219]

hi Sharon, I liked your video very much thank you for sharing, I have two magic mats because mine came in a two when they first came out, I love them, when the get warped looking I just put it in hot water for a few minutes or you can use your heat gun and they straighten right out. Judy

[@BanditsMom-w8k]

I find I just have to take my time on them. I always forget to use the roller thing. Those are gorgeous.

[@cindys7376]

Love your Temu testing videos…fun and helpful 😊 Saw a few dies I want to order now. You’d love the magnetic magic mat, it does a great job of holding all those tiny dies where you want them, no shifting, no washi tape necessary

[@littlebritco1337]

Finally ordered one. Can’t wait for it to come in😁

[@loiebeck8623]

I really like watching these cuts, or any cuts for that matter...

[@cnmjmm416]

Hi Sharon, I like the videos like this. The haul videos are enjoyable, but I like to see some actual creating.

[@cyndicrane7878]

Sharon try using a rolling pin with the triangle box die. I would probably roll it on your bottom plates.

[@susanwells7866]

I really enjoy watching, and listening to you work. I learn so much!!

[@littlebritco1337]

Thanks Sue!❤️😅

[@judymcintire7095]

I usually have a bag on my table and hold the die inside when I trim the little bits then I know it’s not on the floor. Cute dies you chose. Needle nose pliers are what I use. You may need a piece of cardstock for a shim with heavier weight paper. Thanks for doing this.

[@littlebritco1337]

Hi Judy! I like the bag idea. I worry about little metal piece and our pups paws.

[@Colorfullife2046]

For the little pieces that you can't remove i think your cutters are to big i would suggest actual die cut clippers. I think this will help.

[@MrBrockbelinda]

Love your videos. I have bought over 100 cutting dies and only had one die that messed up. I had to laugh when the die jumped back.. a little info if you have a straight edge die tilt it side way where the rollers do not hit the die all at once. I got scared many times until I had someone tell me to tilt die.

[@littlebritco1337]

Thanks for the tip! Definitely trying that next time❤️

[@christineaustin9656]

Sweet little turkey...

[@littlebritco1337]

It is cute isn’t it🦃🍗

[@RoxanneSauer-g5m]

I am not sure if you use "buttons" - and you clip off the back so it will be flat.... YOU need that tool I would send a picture if I cold.. But it does the trick and no left over metal.. have a very short clippers - mine is pink pliers. I have seen it called Precision Craft Cutters they are kind of bent up (to get under) the wire. Good luck and I love your videos.

[@littlebritco1337]

Hi Roxanne! I’m going to see if I can find that tool. You’re right, I need it😁❤️❤️