The Dust Extraction Part 2 - Blast Gates and Pipes

I continue the build of my Dust Extraction System, therefore I make some blast gates to controll the airflow of the system. Furthermore I mount the tubes and build a few holders.
Special Thanks to Fabian Stahl for composing and recording the Song "Cold Fall Night". This is his channel: / smileypopulation
Due to recurring requests, here is a list of the tools used in this video in the order shown in the video:Some of them are Amazon Affiliate Links. This means that if you buy the product through this link, I get a small commission to support this channel. This will not make the product more expensive for you.
Advertisement +++
DeWalt percussion drill DCK795S2T
amzn.to/2VnS9xQ3M
Peltor Optime 3 Hearing Protection
amzn.to/2Vud4Py
3M Full Facepiece Respirator 6800
amzn.to/2YOUG6o
Digital Caliper
amzn.to/38eCHuS
STAR-M Circle Cutter no. 36 High Speed Steel
www.fine-tools...
Bosch Drillpress PBD 40
amzn.to/2uLNg5S
Bosch Table Saw PTS 10
amzn.to/2K6mDDi
Holzmann Mitresaw KAP 305 JL
amzn.to/2YKgwrD
Gramercy Tools Hold Fast 19 mm System Nr. 300710
www.fine-tools...
Bosch Random Orbit Sander GEX 125-1 AE
amzn.to/2uLIk0R
Bessey Clamp KliKlamp
amzn.to/344XuhH
Bessey Toggle clamps
amzn.to/2VZPkYa
Spear Jackson Vice
amzn.to/2YSRHdd
DeWalt Power drill DCD780C2KX
amzn.to/2YOPi36
DeWalt Impact drill DCF887N
amzn.to/2uLWjUD
Bessey GearKlamp 450 mm Nr. 317552
www.fine-tools...
+++

[@Jajaho2]

I like your videos very much and enjoy your tasteful editing.

[@Loulexmakes]

thank you!

[@Jajaho2]

@@Loulexmakes no, thank you und noch einen schönen Nikolaus Abend

[@inconsteveable91]

When using your table saw or any exposed blades, have the blade only slightly higher than the piece. More exposed blade = less safe.

[@Chri8181]

Is that a Scheppach HD12 dust collector? Since it's pretty low cost, can you recommend it? BTW, great video, I would fix the blast gates to the wall or ceiling to gain a little more stability when opening and closing them

[@Loulexmakes]

exactly right, it’s a Scheppach HD12. Well, since it is realy cheap you ain’t getting a high quality product, but the bang for the buck is pretty good. It has enough power for my whole Workshop. But changing the Bag where the Dust is stored is realy anoying since the fixture for that bag works realy bad. And I had to remove a metal pre-filter, otherwise the machine would constantly clog up when extracting chips from the jointer. But after removing that it works just fine.

[@Chri8181]

@@Loulexmakes THX for the response! 👍