The Mandalorian Helmet 3D Print Time Lapse - How to 3D Print Full-Size Helmet In One Piece

[@Eric_Is_The_Name]

What camera are you using?

[@toxicllama6130]

Is your printer the CR-10? That printer seemed good

[@CoolPrintsToday]

Yes, CR-10

[@sonnyharo275]

Did you throw in a new spool while the print was going?

[@CoolPrintsToday]

Yes I had to around the middle of the print.

[@jamesgarner8668]

what size nozzel do you use for this

[@CoolPrintsToday]

0.4mm.

[@michaelknight2897]

How much filament was needed?

[@CoolPrintsToday]

4.8 lbs. of filament

[@michaelknight2897]

@@CoolPrintsToday WHAT!!! How much is on a roll? Damn. Im printing it right side up with no center supports. Lots of people do it that way with no problem. I think that will drop it significantly.

[@byakuzac]

how many lbs of filament do i need for a helmet?

[@CoolPrintsToday]

Around 4.8 lbs

[@Ga77]

can you explain your supports config? amazing pop out

[@CoolPrintsToday]

I use simplify 3d. The settings are: Support Infill percentage is 25%, Dense infill percentage is 70%, support pillar resolution 4.00mm, upper vertical separation layers 1, Lower vertical separation layers 1

[@Sates]

This is so cool!

[@sandragon2714]

Hi. How long did it take to print? What size nozzle? Thanks have a great day

[@yorandb9494]

3days and nozzle 0.2

[@sandragon2714]

Thanks

[@georgesgamersquad1423]

This is awesome

[@flynnduke7431]

This is the way

[@LarkAlrion]

My supports never come off that easily.

[@sandragon2714]

Nice work 👌

[@sandragon2714]

Sorry just saw the end. 69 hours.