The Model Ship - Part 2233

[@soppdrake]

Great idea to use the hull and the vanes as a jig for that fiddly part. And many bonus points for straightening out the bent support. 👏

[@rodadams8422]

Good morning Ron great show looking good at all angles 🎉🎉🎉

[@zakogreen]

Love watching your videos my friend! Keep up the good work and hope you stay healthy!!!

[@roncalverley]

I appreciate the well wishes! 👍

[@dannysnead2852]

Hey Ron, excellent episode tonight, Nice bend on the plastic part with the heat gun, I'll see you tomorrow. 👍👍👍👍🥶

[@roncalverley]

Hi Dan, I had a little bit too much heat on the heat gun. I should've had it set one notch lower. Thanks for commenting again. And yes, we'll see you tomorrow. 👍

[@pebblecreekmodels]

Nice fix on the rudder support tonight Ron. Great video, take care and see you tomorrow.

[@roncalverley]

See you tomorrow Chris! 😊

[@aussiefrenchman-hobbytable9960]

Hi Ron, nicely done 😊😊😊, see you tomorrow

[@roncalverley]

Thank you Marc. We're moving forward --- slowly but surely! 👍

[@garyleblanc2170]

Nice job straightening the rudder support rod Ron. Good episode. See you tomorrow.👍🙂

[@roncalverley]

Thanks! We're making progress slowly. 👍

[@JeffDonahueScaleModeling]

Hi Ron, Thanks for the great video. I don't always comment, but I do watch everyday. Thanks for sharing. Have a great day. Jeff

[@roncalverley]

Thanks Jeff, I appreciate your and Jordan's support! 👍

[@BrianD-h9z]

Good episode, Ron. Moving right along with the sub. See you tomorrow! 👍🙂

[@roncalverley]

See you tomorrow Brian! 👍

[@militarymodellerpaul5932]

Ron, back breakfast viewing 😂 great video. I was worried for a short period on the bending when it started to bend more but you noticed it 😂 you had holder downer incident, was it a knockoff version 😂😂😂 Happy everything Ron

[@ukdave57]

I was a little anxious when you were using the heat gun to soften the plastic but all came out well. As a tip I have found dunking the part in boiling water is just enough to soften styrene.

[@chrismoser3481]

Hi Ron, interesting work with that heat gun. Makes me wonder if there are people out there that change models into completely different models

[@jefffranckowiak8911]

Hi Ron, before you put the heat to the bent part, I would find where it goes and do a test fit first!

[@roncalverley]

👍

[@JimE6243]

"..........your non metric friend." LOL!!! Hard to believe they still have Max's car at the dealership. I'd be fit to be tied by now. They should at least offer him a donor. See ya. JimE

[@roncalverley]

Hi Jim, Yes, this situation with this Subaru is very disappointing, that's for sure. I hope that if I have a problem with my Subaru that they don't have to bring the part in from Japan. It must be a very unusual part that has gone on his car. Something that I guess doesn't happen very often and nobody stocks it. Either that or they're hoping he'll just buy a new car from them.

[@JimE6243]

@@roncalverley "...... hoping he'll just buy a new car from them." OH, I'm sure I would!! Still no excuse for not giving him a loner for car for a Subaru problem. He's lucky he and wife don't each have to get to work at every morning.