This Task Should be handled by a Skilled Mechanic’With the Truck drop spindle broken repair #broken #truck #spindle #incredible #mechanic #mstechnology
Пікірлер: 17
@FlailWilhelm27 күн бұрын
It would be faster, cheaper and safer to drill the back of the housing out to the size of the spindle. Then make a new, from scratch, axle with a backend larger than the housing, then do a shrink fit putting the new spindle in through the back of the housing.
@beardy95129 күн бұрын
Hard to watch😢😢😢
@horstmuller7512Ай бұрын
Wonderfull watching these "super high skilled professionals". They always remind me of the tv series "The Flintstones".
@ilyas.3181Ай бұрын
Уважение мастеру, и орден мужество водителю. Смелые люди, должно быть у них большие проблемы с запчастями.
@dankovalev257Ай бұрын
dangerous, especially on mountain roads
@fredhoyt6900Ай бұрын
Dystopion engineering.
@johnroberts8513Ай бұрын
Should be good for 5mph.
@Bugsy0333Ай бұрын
Well if you repaired it yes i agree !
@johnroberts8513Ай бұрын
@@Bugsy0333 Well thank you for your remote assessment of my skills, if that job meets your approval it says more about you than me! The stub is not even central on the Knuckle, you never weld cold cast steel, and you cool it slowly after you weld it, that's your education for today.
@georgegonzalez2476Ай бұрын
These machinists should keep their bags packed as they may have to leave town at any time.
@AframuneleАй бұрын
To proceed of this part by this way is extraordinary dangerous - -
@keithhayman8959Ай бұрын
If the tool was held in the other side of the tool post , the tool could finish the cut , and not hit the chuck . This is only basic lathe work . Some thing a 15 year old can do .
@paulorth2251Ай бұрын
It's done, that's all I will say.😮
@alexoneintheworldАй бұрын
Жаль нет смайлика "Кровь из глаз" !
@kunar2656Ай бұрын
Ну теперь этой шнягой можно создавать формы для отливки нормальной детали)
@1971FinАй бұрын
Залипательное видео.сначала замер микрометром а дальше доведение размера болгаркой на глазок. При этом нет никакой центрации с посадочным местом под опорный диск-видно биение и радиалтное и осевое в плоскости установки опорника. Эту деталь осталось покрасить и выбросить.