Mine match up. However, in the process of setting mine up, I performed the calibration procedure which involves aligning them with the supplied screwdriver through the holes, then unplugging, replugging, and clicking through the detents as shown in the instructions. I don't know how mine was before doing this because I performed it right away. Yes, it's flimsier than the metal real ones, but considering that the price is down to merely FULL MSRP, we're making progress....of sorts.
@thecouchsamurai8429 Жыл бұрын
I just got the joystick for 30 pounds and I’m so excited for it to come.
@Yengamer Жыл бұрын
Me too! 40€ on blackfriday and it arrives today! I play VR and cannot wait to finally enjoy MSFS2020, Warplanes WW1, Elite Dangerous, DCS and SW:Squadrons with joystick!🕹🥳
@rakon84963 жыл бұрын
You should think about RMA your throttle, just did it with my joystick (Z-axis sensor defect) and got a new replacement within 10 days.
@Go-nb9jz2 жыл бұрын
Does your z axis sensor still work?
@rakon84962 жыл бұрын
@@Go-nb9jz No, it's basically working for some hours and then failing. Don't know why they don't use Hall sensors instead of potentiometers. just waste...
@christopherjackson8457 Жыл бұрын
I've been using this pack since march, finding it very satisfactory. There was a firmware update on installation. I too experienced some disparity, but setting up a different controller setting for the Airbus 320nx by flybywire was essential. The settings are further enhanced in the Flypad on the flight deck. However it is imperative that before every flight these settings are checked and verified. However this is only for the throttle. Onec on takeoff the stick locked up, losing nosewheel and rudder control, causing me to abort, and check the settings, before lining up for the eventual takeoff. Flying with a helicopter setting is too difficult.
@BluGames3 жыл бұрын
nice review Sol!
@wayoutwest73 жыл бұрын
I'm having the same issue throttle offset. Likely will return for that reason.
@arranwilliams2523 Жыл бұрын
lol i just ordered this from my 3D pro, I got a beast PC and game in VR alot and stoked i can upgrade this pack later if i flight sim alot to justify it!
@kaeptnbaloo3 жыл бұрын
Yeah, 3MB Flightsim is a Swiss KZbinr and his result was nearly the same. He also criticised the throttle difference so youre not alone ;)
@hpitura2 жыл бұрын
on mine it is the same. theoretically calibration process should help mitigate this, but the process is cumbersome and not precise. compared to this really nice joystick it is the biggest let down of whole set. be aware.
@Gert-DK3 жыл бұрын
I was thinking about buying it, but difference in throttle is a nogo for me.
@noamplayzgames41683 жыл бұрын
yea same, but its been 2 month did you buy a different one or the same tell me please I need to know.
@Gert-DK3 жыл бұрын
@@noamplayzgames4168 No I did not buy any
@adriangoodman89013 жыл бұрын
You have to calibrate it correctly, you must go through every detent including idle and full reverse, both my throttles are perfectly aligned but at first one was off because I had done the calibration incorrectly
@vitorrodrigues67852 жыл бұрын
@@adriangoodman8901 hey Adrian.. I’m just about to buy this one.. So, can I go forward and buy it? This problem is solved by simply calibration? Im worried about it
@RealLagu3 жыл бұрын
My 8 years old good thrustmaster hotas x is beginning to have some annoying contact issues so thinking about upgrading... The 180€ price is a bit rough tho, so maybe I will survive wit this
@onur73806 ай бұрын
If u answer me ı wıll be so happy. Do you prefer this quadrant or Saitek quadrant ?
@harrymccc25323 жыл бұрын
Anyone else wish they produced a higher spec metal version. The plastic of it all just puts me off
@ValFolarin Жыл бұрын
When I push forward on the throttle, it shakes and lifts up. What are you doing to ensure that the throttle remains stationary and stable?
@moes21683 жыл бұрын
@Threshold Nice review. I know you said you went through the user guides but you did not mention if you did the hardware calibration process. Video guide here kzbin.info/www/bejne/oIesZ5mvatytpJI and written guide here ts.thrustmaster.com/download/accessories/manuals/TCA_Quadrant/TCA_Quadrant-Throttle_Calibration.pdf. NOTE: If you follow the steps, you'll note that the video and guide end the calibration at Idle detent position, some people say as last step you should also move throttle FULLY REVERSE, press the two red buttons and at that point you should exit the calibration. Not sure if that makes a difference but worth a try. Unlike contact based potentiometers, the contactless hall effect sensor's min/max is set in "software/firmware" and needs to be calibrated so the positions are matched. Sometimes during shipping, the slightest movement can change this definition of min/max as the pivot point of throttle levers is really low, the smallest of movements at sensor translates to larger movement at top. calibration will reassign the new values of each detent at a hardware level.
@neunundfuenfzig2 жыл бұрын
you can make an entire asmr video out of this product
@5MilesHigh3 жыл бұрын
Great review, dropped a sub 👍. I am currently using the logitech extreme 3d pro, it is fine but I think an upgrade would be nice as I am increasingly using the Flight Sim. I also do a fair bit of GA flying other than Airliners, have you found that the pack is good for this aswell (especially the throttle)? Thanks.
@Thresholdx3 жыл бұрын
Yes! I spent a day doing some bush flying in MSFS and it handled really well, even the throttle. Hope this helps! ^SV
@5MilesHigh3 жыл бұрын
@@Thresholdx Ok, thank you for the response, I really appreciate it.
@joshfincher73643 жыл бұрын
For GA flying the HoneyComb yoke is unbeatable
@vsetenjoyer2 жыл бұрын
I want to get it to replace my Logitech Extreme 3D Pro as well, I do think it would be good for single engine as you can use one throttle for throttle and the other for prop or mixture.
@5MilesHigh2 жыл бұрын
@@vsetenjoyer nice, my TCA is great. I tried the mixture thing, didn't work nicely for me but might for you
@RealWorldAviationandGaming93922 жыл бұрын
Well this is a product problem. Everyone that purchased the throttle quaudrant has a calibration issue and those that received a free set to display and show on their channels never had a problem, great out of the box...RIGHT!
@jansallinen88062 жыл бұрын
Hey guys and gals. I´m interested of this product. No, I don´t use it on to fly airbusses but HUMONGOES battle ships in space. I definetly like the joystick. That is familiar to me but separet accelerator is new to me... Yeah, mouse fly, I know! Do you advice me to get this one or some other product? Mind you that my money is limited, so no thanks to those 500€ stuff, pls :) Thanks in advance
@murapia2 жыл бұрын
anyone know if this is compatible with FSX?
@Jasemtl3 жыл бұрын
My throttle is also off a bit
@doubleb94842 жыл бұрын
does it work well with combat sims?
@askarhun86872 жыл бұрын
is this simulator useful for any aircaft ?
@johntristangarcia23993 жыл бұрын
does it work with FSX?
@lanspick57872 жыл бұрын
no
@DavidStanko143 жыл бұрын
Is it possible to like scre both the engine levers together so is easier
@doggiehowzer3 жыл бұрын
It comes with an Allen key/screw tool that is designed to slot into the a hole that keeps both engines locked together. It isn't as slick as the one on my Warthog throttle but it also works well enough. The box I just picked up of the Airbus combo today has an extra instruction sheet showing you how to calibrate the throttle 1. prior to connecting the throttle to the PC, lock the two engine throttles with said-tool, press and hold down one of the set buttons before plugging into the PC, then step through the 5 major detentes, clicking the button at each step. That should align both sides of the throttle. You can download the steps from a PDF from Thrustmaster support
@DavidStanko143 жыл бұрын
@@doggiehowzer ok ive decided im jjust gonna have it as it is but thank u a lot for the help anway
@DavidStanko143 жыл бұрын
@@doggiehowzer actually can u tell me how to do the Allen key thing pls
@DavidStanko143 жыл бұрын
@@doggiehowzer nvm ik now
@doggiehowzer3 жыл бұрын
@@DavidStanko14 sorry - didn't see the message. you can download the calibration guide on the thrust master support site for the illustrations
@indian.techsupport2 жыл бұрын
You have to calibrate your throttle if you havent!
@TheOnlyEn3 жыл бұрын
what planme are u flying at 6:40
@cashoutcraig96003 жыл бұрын
A350
@Leonidesu3 жыл бұрын
350 aud? dang that's so expensive 😬
@lachlanp41983 жыл бұрын
I just bought the pack for 250aud from Amazon us
@meow21482 жыл бұрын
Down to USD 90 now, snatched mine up ASAP
@TheOnlyEn3 жыл бұрын
where do u download the a350 for free? witht he right cocpit