tips on installing kenny bell boosta pump

[@rebea100]

Best video on KZbin describing the Kenne Bell BAP install options. I didn't want to run the dial or vacuum sensor. I'm going to run a trigger of my stand alone to activate the BAP with a relay.

[@johnnysprocketz]

do you take the two sets of red/blk wires and connect red/red, blk/ blk OR red/blk , red/blk?

[@323smiles]

question, i bought the KB89069 BAP. I see you have 3 black wires. i only have 2. is this because you have the dual? I the long wire that think connects to the knob that turns up the amperage i think. I liked the set up you have. Can i do that wit mine?

[@s2oooo]

I'm stuck on 14v at the moment with no voltage reg connected. My boost switch doesn't appear to work. Will joining the red and black on both cables give me a constant 17volts? cheers Lee

[@Diesel3R]

Are the wires the same color to wire to for my 03 GT?

[@turbinatorlou]

Will this boost a pump be sufficient enough to support 6-650ish rwhp coyote swapped engine using a 340 lph intank pump? I have a 255lph in it at the moment but just wanna make sure I'm gonna be covered. This will be a boosted coyote btw. Any help will be greatly appreciated.

[@yzfr6ws6]

Hey man on my boost a pump I wanna use my voltage regulator knob but I do not wanna use The vacuum lines do I tie them off red to black any info would be useful thank you

[@eightsixmotorsports]

Yes just connect them together

[@georgegiannopouloscamarozl1028]

I have ZL1 2015 manual the pump boost more hp 7 horsepower or 10 horsepower

[@eightsixmotorsports]

thank you please subscribe... More vids to come soon