Toyota 3RZ Cylinder Head Removal - Part 2

This video shows the steps to remove the cylinder head from the tacoma. (Part 2 of 3)
Engine is a 3RZ-FE 2.7 L inline 4 with coil pack and 5 speed manual transmission.
Truck is a 1997 Toyota Tacoma 4WD standard 2 door pickup.
Music: Cleerance Clearwater Revival - Fortunate Son

[@jonmercmercier6315]

THIS IS THE BEST HOW TO VIDEO IN THE WORLD. I SALUTE U SIR.........ALSO, NICE TACO

[@ajseuol1864]

Okay rookies listen up. You do not need to remove the intake manifold or exhaust manifold. We've both intake and exhaust manifold attached to the cylinder head pull the wiring harness through the firewall disconnected from the computer and take it out as one sembly. It's much easier taking the intake off when it's on the bench and Don't Unplug fuel injectors you don't need to. Hope this helps. I know it will.

[@daveyjoseph6058]

eh

[@kevinbr3197]

HOW THE HECK DO U REMEMBER WHERE TO PUT ALL THOSE HOSES

[@DocSpratley33]

Great video! i have heard people say you have to drop the pan to get the timing cover off? apparently the pickup tube for the oil is attached to the bottom of the timing cover? I have a 95.5 distributor style 4x4.

[@ryanmodderman4459]

THank you!!

[@loganking98]

Is the connector at 0:27 the IAC valve connector or the Throttle Position sensor connector? My engine will start but only run with the gas pedal pushed down, it will not idle because i broke that wire

[@BlueSky-sv6ye]

Please help for some reason I cannot put the fuel inlet pipe bolt back in tight it won't thread? In