Toyota 4.7 Transfer Case Re-Gear Tutorial

[@LittleRiverKingfiser]

excellent! very helpful and well explained! thank you for this

[@rudetoy8264]

Perfect, just what I needed to keep stock transfer case simplicity but allow slower crawler gears👍

[@thrashmetal7588]

I’m waiting for Marlins gears to come in now so I can do mine!

[@reneg1366]

Next mod on my 85👍👌

[@jhambuladventure7142]

Good job 👍👍

[@TheRandomDead]

Heat them up in the microwave?

[@ParkerWismar]

Hahaha, theres an ave video on it. If you wrap them in a bundle of wet paper towels it will stop them from sparking and because water can only get so hot before becoming steam it heats them reliably to ~212F. Works pretty well and only takes a minute or two if you dont have a fancy bearing heater!

[@ParkerWismar]

kzbin.info/www/bejne/goeydX2jZZqjotk

[@mrJohnny375]

Too late, now I’m doing a microwave rebuild.

[@JamesSmith-sc3xe]

With the bearing kit do u have to order a sepret kit cause the case is factory 21 spline and not 23. In saying that the new 23 spline comes with the bearing for main shaft or are they all the same size

[@ParkerWismar]

Not sure, I ordered a seperate rebuild kit and ended up with one or two duplicate unused bearings. Call Marlin, they're the experts!

[@egtallday]

What did this go in?