Toyota Camry with JBL | Beat-Sonic Amplifier Installation

[@davolbc]

Gotta love it!

[@BeatSonicUS]

Thanks!

[@kentran229]

Hey I got a question, I got this harness that has remote out and RCA that is all plug and play in the same exact plugs where the amp is installed, do you think it’ll still work if I plug that with the sub?

[@BeatSonicUS]

Not sure but you should check with wherever you got it from

[@mikegent2676]

Great amp put mine in stock Toyota Tundra Crew Max sounds great

[@BeatSonicUS]

Awesome! Thanks for your feedback!

[@gilewihen4480]

My car is a 2018 Camry Hybrid and I have a reservation for installation through the official Korean dealer. I would like to ask if 12 o'clock in the rear and 3 o'clock in the front is the most ideal setting for this vehicle model.

[@BeatSonicUS]

Yes, however you may adjust it to your liking.

[@89Epro]

Does this improve rear speakers or front only ?

[@BeatSonicUS]

All speakers

[@b18c5turbogt35r]

i just bought a kit form u what should i put the setting at because right now i have it about maxx out

[@BeatSonicUS]

I recommend to leave it at 12 o clock

[@b18c5turbogt35r]

@@BeatSonicUS okay how about when i put in aftermaket speakers than

[@omaravilez7140]

What percentage increases the music with that amplifier?

[@BeatSonicUS]

About 80%!

[@b18c5turbogt35r]

how much of a improvement on aftermaket speakers

[@BeatSonicUS]

That would vary with the speaker. We recommend a 4 ohm speaker

[@b18c5turbogt35r]

@BeatSonicUS I plan to use the alpine x series or r series or e series speakers

[@marloncordero6233]

Would this work well and improve sound quality on 3ohm JBL’s. These are aftermarket not OEM

[@BeatSonicUS]

Specifications call for 4-8 ohm speakers.

[@marloncordero6233]

@@BeatSonicUS so since my factory speakers where 4 Ohm then this would make a significant difference in music quality over my 3 ohm JBL’s?

[@BeatSonicUS]

@@marloncordero6233 Running 3 ohm speakers may cause the amplifier to run hotter than usual. The amplifier has a fail safe protection built in so that it will shut off if it becomes too hot. As long as you keep the default gain setting at 50%, it may work without any issues.

[@RobHTech]

sounds like it just barely raises them mids, which is why it sounds like it does. For over $380 for my 2022 WRX it's not as good as making my own plug-n-play with 4 ch amp.

[@BeatSonicUS]

That’s how it may sound from from listening to it from this video but the audio improves in all spectrum in a vehicle. This is $299 and not $380. Installing this will take 30mins compared to a different 4 ch amp may take hours. And results may vary