Trail Forged bumper on the 2004 WJ

[@4321pat]

Awesome, Ross is such a good sport 😂

[@scottjensen8912]

They best option for the washer fluid reservoir is to replace it with a zj rez it fits up over the fender. There are a couple youtube videos that show how to do it.

[@wjoverland5109]

Thanks! Ya after this video I took off the washer fluid reservoir off ZJ reservoir is in the shopping cart, just been throwing water at it when it gets dusty! 😂

[@GReerKid1989]

This video is phenomenal.

[@wjoverland5109]

Thank you!

[@BlueberryFarm900]

Oh, I'm dying! One photo. Even ONE PHOTO of the finished bumper (no concern for pre-powdercoat) would have been phenomenal. Is it too much to ask? And that music! I thought I told you to leave that effed up music at home.

[@wjoverland5109]

Thanks for the input. 🤓 I will take that into consideration for the next one.The bumper is in all most all my videos, If you wanna see what it looks like done. I did not end up powered coating it ...I'm inpatient.. lol.. I sealed It and sprayed bed liner on it so I can touch it up as I go and I really don't care, I'm sure I'll end up with problems down the line. I'm defiantly not a pro! just stumbling along as I go! good luck if your installing the bumper👍

[@andrewjoseph8739]

This bumper seems like a huge pain in the rear to install. DTill Fab makes an awesome bumper and it is much easier to install.

[@wjoverland5109]

i'll have to check that one out . it wasn't the easiest that's for sure!

[@Zach-sg5uu]

That much work why not make it square in the front?

[@wjoverland5109]

Well it’s s all about the approach angle. It definitely helps. It’s not for everyone to do the DIY version… if you order one to be built. It takes quite awhile to get it built and delivered. I have zero patience…

[@توفيقالجماعي-و1غ]

measurements

[@wjoverland5109]

there really wasn't any measurements its all pre cut. you just have to figure out how to bend it and weld it. anyways its a tuff job building it let alone filming it.. lol

[@Shnierpiffle]

That better cost 100 dollars.

[@desertd2609]

I built the center section a few months ago and I agree the instructions for install are garbage! I still haven’t built the “wings” because I didn’t buy this kit for myself, the previous owner of my jeep did and he ordered the ultra high clearance version and I don’t want that so I need to modify the wings to be a little more bulky. I would just order a set but by the time I pay shipping on them it’s over $400. and I just can’t justify that expense!

[@wjoverland5109]

yeah it was tuff but I really do like it!

[@wjoverland5109]

yeah the high bumper was to skinny for my taste.