Trail Sight LED Lights Installation | Ford Bronco | MABETT

[@mabett2313]

Thank you for your feedback. I have already submitted a request for improvement of the instruction manual. If you have any questions or need clarification on the installation process, please feel free to leave a comment below this post.

[@johnmezera2862]

These instructions are far better than the pictures in the kit!

[@juddguilbeau1759]

Can i hook this up to an aux switch?

[@douinbroncothings2791]

I'd recognize that garage floor anywhere!!.....@cupradesign/Xanthus!😉

[@CUPRADESIGN]

Ha! Busted!

[@buhner1991]

I have a dumb question. I was installing these on my 2024 Wildtrak. I removed the top bolt on the drivers side and took out the original trail sight. I then put in Mabett driver's side one (yes I installed the weather stripping) and the original top bolt would not thread and tighten down, I have no idea why. I double checked about 20 times it was the right bolt and placement. I even tried the bolt without the trial sight in, and it still wound not thread. It was almost like the hole was too small. I wound up using the bolts provided in the kit and it worked just fine. Has anyone else ever had this happen to them on their Bronco?

[@freedomsrt8]

Looks great 👍

[@markhickok9160]

I ordered these and really like the TURN SIGNAL. Bright!. But the printed instructions and videos leave a LOT to be desired! You leave out a lot of the difficult stuff. Wiring for this is odd. Why 3 connectors but you use only 1! AND - as far as I can tell - this is NOT dual! I only get turn signals. I do NOT get white running lights. So imho there is some decpetive advertising going on here.

[@TheChuck1960]

Should’ve showed more of the wiring.

[@craigeastwood9941]

When will these be available?

[@stevenplymale5610]

How much are these going for

[@SickMy_Duck]

Found on Amazon and $270 for pair

[@I_heart_fishing]

That was worse than your terrible print out instructions which I didn't think was possible.. congrats