RadioMaster Pocket Setting Up Flight Battery Voltage Telemetry

[@wvsimoesjr]

Thanks for the tip. Great idea of applying a delay before the warning - I will program the same in my TX16S. Have a nice weekend!

[@the-happy-RC-flyer]

Thanks, you too!

[@WulrekaDavid]

why my rxbt not showing the voltage? how to fix it?

[@the-happy-RC-flyer]

Have you discovered New sensors in the Model Settings, Telemetry?

[@WulrekaDavid]

@the-happy-RC-flyer Yes, all telemetry sensors have values, except rxbat not showing the voltase, there is only a line

[@the-happy-RC-flyer]

What receiver are you using and does it have a voltage sensor wire?

[@dji_mharyhu]

i did this and set the voltage to 11.1 the voice just say critical low battery even with a fully charge battery...

[@the-happy-RC-flyer]

How many cells does your battery have? And did you check the voltage with a multimeter? It was giving the warning because the connected battery voltage was below 11.1 If you had a 2S battery I would set the alarm voltage to 7.4 volts. Some pilots do take their battery voltage down lower than 3.7 per cell but I would not recommend that.

[@dji_mharyhu]

@@the-happy-RC-flyer its a 3 cells brand new packs, freshly charge 4.20v each cells, i did check each cells with a multimer.

[@the-happy-RC-flyer]

@@dji_mharyhu Then you need to take a look at the sensor details and calibrate the sensor to display the same voltage as shown on the multimeter.

[@gluino]

That works. But does anyone know how to get chosen Telemetry sensors displayed on any one of the "flying" pages?

[@the-happy-RC-flyer]

The telemetry sensors only on the Telemetry screens.

[@mayankyadav8654]

Please help me my radio master boxer is not working the screen just blink

[@the-happy-RC-flyer]

Hi, remove the batteries and replace, check they are charged bottom USBC port. Is anything happening when you hold down the power button?

[@mayankyadav8654]

@@the-happy-RC-flyer the screen just powers on and shuts down immediately and repeats the process several times faster

[@mayankyadav8654]

@@the-happy-RC-flyer provide me your email I will provide you the video of the problem

[@the-happy-RC-flyer]

Is there an SDcard in the radio? Check it in your computer please to make sure it is not corrupted? Have you updated the firmware recently?

[@mayankyadav8654]

@@the-happy-RC-flyer the sd card is fine no I didn't update recently

[@FiatPandaSelecta]

Je laat niks zien, we willen voltage zien in scherm

[@the-happy-RC-flyer]

You just need to add the telemetry sensor to the telemetry screen. Search my playlists on how to do this.