Thanks for the demo. On the convex one, will it end with 18 degrees at the "very" apex, or will it be 18 + 7.2? Also, can you do with a stone of that width a convex sharpening of the curve as you approache the cho, or would that need an even thinner one? Or do you leave that part sharper, with a flat grind for fine cutting? I'd also expect the angle you end up with to depend on the length of the stone...if that makes sense.
@ShelleyRaskin2 ай бұрын
I keep it consistent the whole width, I suppose you could keep a section full flat instead but I would probably need to tape a section then go back and finish that bit off. Yes 18 plus 7.2 at the edge, doors not have to be 18, I could have made the initial angle anything abut always with 7.2 added, although the sell other angle adapters beside the 7.2.