Tutorial-10: Circuit Design with Vendor Components

[@karishmagowda9749]

Thank you so much for your videos, sir! I have been following your videos for all my rf designs and they've been very helpful. I tried em cosimulation for low pass filter using ideal components and it worked just fine. But when i replace the ideal components with practical components, I'm facing issues regarding post layout simulation. If you could please help me out in this regard or make a video on the same, it would be highly helpful. Please do consider my request. Thank you

[@BhargavaAnurag]

See my other comment on this.

[@peimanparand]

very helpful thanks

[@MR-qi7fc]

Hallo, wenn I simulate it always shows error "Unable to access libarary: muRataLibWeb". What does it means, what to do to get rid of this error? Thanks, Jiyuan.

[@BhargavaAnurag]

Hi, I would recommend you to contact local Keysight tech support team for help. If you have added Murata library in ADS then it should work properly

[@MR-qi7fc]

@@BhargavaAnurag OK. Thank you very much!

[@joyceyu2038]

I got this error as well, and have not been able to figure it out.

[@BhargavaAnurag]

@@joyceyu2038 you simply need to contact your local Keysight tech support team to get help

[@EduardoNavarroSabariegos]

I cannot see the recommend components from Murata library in the schematic window. I´m using version 2019 ADS. Could you please help me?

[@BhargavaAnurag]

You can download the library from Murata website and use the same in ADS as shown in the video.

[@zaidinajah8741]

If i understand very good the video, it gives the difference between real and ideal components, Yes?

[@BhargavaAnurag]

Yes it does

[@souparnika6931]

Sir, when I was simulating a transistor of CGH31240, It is throwing an error showing that, Error detected by hpeesofsim during netlist flattening. Touchstone file parser error: File 'C:/ADS2014_wrk/CGH31240/packaged_wrk/data/Input Network. S3p' Does not exist or not accessible. What does it means, what to do to get rid of this error? Thanks, Naresh.

[@BhargavaAnurag]

Hi Naresh, Ideally you should contact local Keysight tech support to help you with this but for this one time I will provide reply to your query here: 1. It seems you S-Parameter file name has space in between Input and Network and also the extension seems to have a space after . which is not file naming practice. Kindly rename the file name to something like Input_Network.s3p and update the same in your SnP block in schematic and hopefully simulation will run fine. Other observations: 1. I see that your main folder is directly created on C:\ drive which is again not a good idea as Win10 OS will have lot of restrictions to do any operation on folder existing under C:\ so it is better that you keep all your work under C:\users\ folder 2. I see that you have named the work folder as ADS2014_wrk which is again not good because _wrk is the extension used by ADS for workspaces so name it something like ADS2014_Work etc Hope this helps.

[@souparnika6931]

Sir, thanks for prompt response... I will follow your guidelines... thanks

[@vamshikrishna2005]

Sir can you share a gdpk 180 nm MOS transistor file

[@BhargavaAnurag]

Hi Vamshi, Kindly reach out to Keysight Tech Support team and they will help you with this request.