Type-C 15W 3A 18650 Lithium Battery Charger Module DC-DC Booster UPS Power Supply Converter 9V 12V

[@UnboxWithTest]

*Ask your questions* 👇

[@FroggyTWrite]

do you have the ability to test how clean the power is on that unit. another review found it was quite dirty, and i'm wondering if that's the case with this unit too

[@UnboxWithTest]

when i get a chance i will check it out

[@HGanhao]

can i use the UPS output on the 12v version to charge a 3cell lithium battery? it has a 12v bms, overdischarge and overvoltage protection. it would be neat if i could charge 2 cells , plus the 12v battery

[@hamzaraheel4598]

​@@UnboxWithTestinstead of 18650 cells, can i use 70cc bike's battery with it?

[@lospolloshermanos1863]

It chips get heated quite quickly. Os it normal

[@archosereader5918]

Нашел сам. Может кому пригодится: если заменить R7 на 91кОм, то на выходе будет 12в, если заменить на 62кОм - на выходе 9в, если заменить на 30кОм - на выходе будет 5 вольт. А если прицепить, какой-то переключатель на три положения и к каждому контакту припаять по резистору, то можно переключать выход на 12, 9, 5 вольт.

[@epedja]

Exaclty what I was looking for. I need 6V output but I could nowhere find any details how to set output voltage. Thanks a lot!

[@davevengelen]

What value is needed for 4.2v output?

[@Gaitaver]

Друже! Не підкажеш, вона при повній зарядкі АКБ вимикається та вмикається? Бо в мене є саморобна , сама вимикається та не вмикається

[@alexandrefortes9347]

Legal, ganhei um de 5v para 12v, minha preocupação era se na bateria ficasse 4.2v que é a carga máxima para carrega-las. Obrigado pelo vídeo. Além, de um carregador, pode ser um belo power bank para um Modem. Tem algumas ideias boas para oq posso usar?

[@DanielsGameVault]

What happens to the 12/9v output when connected to USB with no batteries inserted ? You only measured the battery terminals, not the output. Does it still boost to 9/12v off the USB port ? You'd be limited to the current of the charger then, but it would still work...

[@UnboxWithTest]

I haven't tested it that way yet, I'll have to check it out

[@dennisdejonge1629]

I have tested it without batteries hooked up by USB, it boosts the power to 12.58v just like with batteries. The board acts like with full batteries (blue led on).

[@archosereader5918]

Какие номиналы R7 для выхода 12в, 9в, 5в. Ведь заменой всего одного резистора можно менять выходное напряжение. У кого есть такой конвертер на 9в и на 5в, напишите какой у Вас стоит резистор? Если не разбираетесь, то хоть маркировку на нем. Заранее спасибо.

[@archosereader5918]

What is the value of resistor R7 for output voltage 12v, 9v, 5v

[@ChristianWengel]

It depends on the other resistor, search for "XR2981 datasheet".

[@Wandhaservis]

help mee the ic charger short ,seri dekat ic charger..

[@psykopat81]

Is it based on TP4056? Is there overcharge and discharge protection?

[@UnboxWithTest]

The manufacturer specifies Lithium battery protection: over-impulse, over-discharge, over-temperature, over-current protection (if the short circuit enters the protection state after misoperation and does not output, connect 5V charging to automatically activate the recovery output).

[@ancelmosena9800]

Hasta cuantas Baterias en Paralelo Soporta?

[@UnboxWithTest]

2

[@ancelmosena9800]

@@UnboxWithTest gracias por Su respuesta, Saludos!

[@moamenmoamen2240]

Does it work as ups, when the electricity is cut it transfers to the battery? Or only charging the battery

[@UnboxWithTest]

Yes, it works like a UPS or power bank

[@dennisdejonge1629]

The device(ups) acts as an always on device(ups), it wil pass through power and if power goes down it wil use the batteries power and convert it to 5V/9V or 12V according to the specified board you got.

[@steve6375]

What is max current that the batteries can be charged at? If only 1 battery fitted, what is max charging current? e.g. LiPo battery instead of 18650.

[@ДмитроБалушка]

1A, but I recomend 800mA (R prog tp4056 - 1.5kOm). 1 or 2 batt - current is const - 1A (in default - R prog 1.2kOm)

[@steve6375]

@@ДмитроБалушка Thanks, I just got mine a few days ago. The 5V Boost cct seems quite efficient too. Batteries are arranged in parallel. I used a LiPo 1800mAh pack.

[@fernandol7810]

What is the voltage in 5+ and 5- when only on batteries

[@UnboxWithTest]

5+ and 5- you mean temperature?

[@fernandol7810]

@@UnboxWithTest I want to know if the 5v+ is active(has any voltage) when the batteries are in the battery holders but the usb-c cable is disconnected

[@EzequielPR]

​@@fernandol7810 theres no voltage, those are just connected to the usb 5v

[@dennisdejonge1629]

Have checked it and my multimeter shows 0.10 volts, with 2 batteries or 1. There are many brands of this module(I got the cheapest) maybe mine is not the best Quality).

[@jessyterpoorten7197]

I need this but whit a switch i can’t find it. This module drains 4.8 ah in 14 days i need one whit a switch to turn of the battery

[@UnboxWithTest]

I think that now the demand for them will grow and many different options will appear

[@dennisdejonge1629]

Maybe a solar panel with usb c. Did not know that these modules draw this much power. For now the best solution would be a separate battery holder>cables and a switch on the positive side. Or desolder the battery holder and put cables and a switch.

[@jessyterpoorten7197]

@@dennisdejonge1629 i tested it now for 30 days i removed the red led when the power is off and my batterys 3000mah dropped 0.2 v so if you remove the led is will not drain as fast as the specs say in the listing

[@miruee]

Battery in parallel or series?

[@UnboxWithTest]

parallel

[@vasylp94]

What current?

[@UnboxWithTest]

The manufacturer declares the following modes of operation Output 5V: current 3A output 9V: current 1.6A output 12V: current 1.2A

[@enriquerodriguezleonardo3125]

The one I have is rare. I bought the 12v one and connected it to a router and its voltage drops and drops to 8v or 9v, it is not very stable and there is an electrical noise sometimes PS: the router uses 12v and 1amp is what it specifies in its source, I am doubting if Is it worth it for the voltage drop and how can I fix that?

[@_BagusSeto]

can connect to raspberry pi 4?

[@UnboxWithTest]

I don't know, you have to look at the current and voltage this device needs.

[@niknitro8948]

Can be used to power a 5v usb Cam like Yi home, and connect a solar panel to recharge the batteries during the day and use battery during night?

[@UnboxWithTest]

Thank you for your feedback! 😘

[@OFCIFR]

Yes I've used to power an esp32cam with 5v version

[@sreeramdassreeramdas1732]

Buying Link please

[@UnboxWithTest]

The link can no longer be found, search by image

[@luckystrike5763]

Link

[@deshantortv5633]

2 rauter dusnot play

[@mdjobayerislam4748]

Modiul model pls

[@UnboxWithTest]

There is no model as such, just search by video title

[@rahuljain972]

Buying link

[@kiranduguju1949]

Aliexpresa jindabad

[@hamzaraheel4598]

instead of 18650 cells, can i use 70cc bike's battery with it?

[@UnboxWithTest]

I don't know, I need to see if the current and voltage match

[@GhettoArabSage]

How to get 5v output?

[@UnboxWithTest]

Look for boards that work on the 5V output, they are on sale on Chinese marketplaces

[@RaheEl_Qaisrani]

got mine got when i insert the 18650 cell its ic start to heat to the point of burning is it same you u guys or have i got a faulty one ?

[@mostertgerrit]

same problem, did you find an answer?

[@UnboxWithTest]

Unfortunately, we don't know the answer, as we haven't had a chance to use it for a long time

[@RaheEl_Qaisrani]

@@mostertgerrit unfortunately no, it was waste of money

[@lospolloshermanos1863]

Same problem did it survive?

[@dennisdejonge1629]

Where the batteries put in the right orientation, flat top batteries confuse me aswell(had to check 3 times before putting them in). Or was the load too great.

[@DrAisha-dh1kq]

sir my router requirements are 12 volts, 2 amps for Huawei, will it work?

[@UnboxWithTest]

I think it's up to 1 amp.

[@tabineshhtc]

it will work perfectly bcoz your router 12v 2a max but it ll use only 5 to 7 watts most of the time.

[@BabarAli-lr6xe]

I am using this gadget for my router 12v 1.5amp .it working good

[@zerogamer9242]

Buying link and price??​@@BabarAli-lr6xe

[@ferryagustyan]

Output 12,6v How many Amperes sir?

[@UnboxWithTest]

1

[@christiamvogl1515]

15W. ...i=w/v....i=15w/12.6v...~1.2A...

[@OFCIFR]

How can i measure the mah of a battery using this?

[@dennisdejonge1629]

You cannot, for that you need a charger that has that function or a dedicated tester for 18650 cells.

[@Shri_Bhoorakaka]

Wow . I have just got my module today ... Thanks for video ..live from India

[@giupeppe6380]

Is there a way to power it off? I see that with the batteries inside the led stays on.

[@UnboxWithTest]

there is no switch. batteries need to be removed