U3 L7 | BSR Mode example| Subroutine for 10 msec delay| Bit set reset mode Subroutine | AKTU 16-17

#8255
#bsrmode
Subroutine for bsr mode
Subroutine for delay
aktu paper

[@rohitsingla7681]

These teachers hats off and given professor rank at university. Not that boring and complex teachers who teaches with no interest.

[@TechnoTutorials2783]

Thanks dear for feedback But thoda jada ho gaya

[@rohitsingla7681]

@@TechnoTutorials2783 I will give this feedback only when I understand fully.

[@nalinksri2497]

Ma'am thank you so much for your guidance your videos really help me in today's microprocessor and microcontroller Paper 😀👍

[@TechnoTutorials2783]

Thanku for appreciation I have just seen the paper , paper was very good Thanku for watching U can refer digital communication playlist for next sem.

[@nalinksri2497]

@@TechnoTutorials2783 ok ma'am 👍

[@srijanisallyouneed]

Why we need to write 6:55 part?😢 Our prof shown just 1st part of it🙏🏻 please explain

[@TechnoTutorials2783]

In program 2nd part write Subroutine for delay That's why I have written If nor asking for delay then it is not required

[@Shivam10253]

ma'am yeh program wale question ke liye konsi wali unit hai, jis se yeh pata chal jye ki yeh mvi, lxi, kyu and kisliye use krte hai, because i just start unit 5 only

[@TechnoTutorials2783]

Mvi 8 bit ki data ko.load ke liye And lxi 16 bit ke address ko ya 16 bit Data ko register pair mai load ke liye Unit 2

[@Shivam10253]

@@TechnoTutorials2783 ohh oakyyy, thank you so much, ma'am

[@AdityaGrover-ly9jf]

Mam OUT kya Hai ye or Iska use kyu kiya and MVI command ka.use kyu kia MVI A,0FH

[@TechnoTutorials2783]

Out is used to transfer the content of accumulator to port address

[@StudyWithCuriousExplorer]

Maam set reset wla to smjh aa gya but program nhi smjh aa rha🙃

[@TechnoTutorials2783]

Ok Tell me ur doubt