UC on UCS - Fabric Interconnect Setup

[@ramvignesh3898]

After configuration SOL , unable to access receiving the error Cisco serial over lan close the nework connection to exit

[@Soundwave-F7Z]

If we wanted to upgrade from 6120xp to 6332, how difficult would you say doing that is? Is their videos of how to fully upgrade a UCS infrastructure...FIs, IOMS etc.. Thank you!

[@larose7880]

please how can I determine the password used to access putty??

[@gaidamacka]

what is port you used for config?

[@dipeshshah6478]

Thank you very much Jason... it really very easy to setup... i was always wondering how do i start with FI setup... :-)

[@rdwytnblue]

Great video, thanks for sharing!

[@larose7880]

hello.it is possible to make configuratin of fabric interconnect from virtual machine? because I have not been able to do it with Putty because he asks for a password when I did not put any password

[@1jasonmurray1]

If it asks for a password then someone has completed some configuration on it. You may try consoling into it directly. If one has been set and noone knows the password then you'll have to go through the password recovery procedures.

[@larose7880]

I want to configure the interconnect fabric but I can not connect with putty because it asks for a password, what is the password

[@clayton7443]

Good stuff. Thanks

[@30lbs]

none of these videos or guides make any sense. i dont understand how anyone is connecting to it to get any output from it. mines brand new so it doesnt have an ip.... so how can i use the gui and config it if i cant access it at all?????? even the steps from cisco make no sense cause it says step one enter the gui. step 2 use gui to config the ip....... makes no sense at all... cant access it without a configed ip and cant config the ip till u can access it..