Universal Car Alarm Installation + wiring diagram explained

Chinese car alarms are cheap but useful if you are willing to sacrifice some reliability in the long turn. This one cost around 15-20$ from the local shop, works okay.
‪@MeFixingEverything‬
Car alarm installation,car alarm,hardwiring alarm,alarm system,Installation,alarm,HOW TO INSTALL CAR ALARM,PAANO MAGKABIT NG ALARM,CAR ALARM,KARRFASSST,how to install a security system,how to install a alarm,installation of an alarm,vehicle alarm,wiring an alarm

[@aristotlerivera6799]

I need the diagram because I cannot understand your tutorial😂

[@TylerBevan-l7m]

Im having a hard time tryna figure my central locking out ive tested with multimeter and im pretty surem my locking is positive input but does not work when i try connect to alarm wires do u have any tips thanks

[@MeFixingEverything]

Have a look in a forum or FB group if someone already installed a alarm. Will be a lot easier than trying by yourself especially if you never did it before

[@TylerBevan-l7m]

@@MeFixingEverything ive read a few things and been told i need to install a dei 341m as the locks output is a positive feed and surpose to be negative to wire upto my alarm do you know much about them?

[@steveangelobecerrafuente5072]

Traducir texto con la cámara Hello, I am installing the same alarm but the opening and closing of the locks does not work with the white and white and black cables, the orange and orange and black, should they be joined? 

[@MeFixingEverything]

There is 6 different ways of connecting. Unfortunately I don't remember what I did back then but look for a few more videos, especially pull.to ground explained wiring diagrams. Every car model.is different.

[@steveangelobecerrafuente5072]

@@MeFixingEverything I already fixed it, I had to connect the yellow and black yellow to negative and the rest was fine, thank you very much for responding anyway

[@jameswambuamutukumutuku2984]

Installing not shown well understand

[@MeFixingEverything]

Will try better next time.

[@jeffprcevich1651]

where are two white wires connected to? For what reason does one need a signal from brake switch? Thanks

[@MeFixingEverything]

Brake switch signal is for programming. Two white cables I don't remember, but have a look in the video I have the wiring diagram shown

[@MeFixingEverything]

I had a look , connects to the control wire on the central locking. Where exactly depends on your car.

[@jameswambuamutukumutuku2984]

It must car use door switch

[@psycopper1]

After 5 minutes, if you step on the brake pedal, the doors will automitically lock itself.

[@alai]

Is it possible to connect directly to central lock unit? Thanks

[@MeFixingEverything]

Maybe Yes, if you know the pin out.

[@alai]

@@MeFixingEverything yes, i have it, but i don't know the necessary signal to do the actuators work 🤔

[@psycopper1]

Connect the white wire with the brown and white of the central lock module.

[@alai]

​@@psycopper1 thanks! Is white and brown also in the Mercedes Sprinter of 2005 year?

[@helderdecaires2675]

I’m having hard time to programming the controllers any help please

[@MeFixingEverything]

I did not had to do anything. Just worked