USB BDM NT Program ECM E40 (MC68377)

[@tschuorscustoms928]

Hello, I am new to this. I am having an issue with a ECM for a Honda jet ski. It has an issue with the knock sensor. I found the area to connect to the ECM. Would you be able to guide me on how to get into this ecm and delete the knock sensor code all together? Thanks

[@usbbdm]

@@tschuorscustoms928 I am not familiar with this ECM.

[@jovanblocker325]

Can you remove VATS with this system

[@rhinomangf]

Good morning. Just found your video. If an E40 ECM is dead, but the flash itself can be read/transferred, are there microcode updates on the processor as well to transfer, or is the flash itself sufficient? (2006 Hummer H3). Thank you.

[@usbbdm]

As far as I know,yes it is enough.

[@emersonurbina8042]

I have 2 e40 ecus that crashed during programming and will not communicate anymore is there anyway i can send them off to you and have tou recover them for me

[@usbbdm]

Do you have proper backup? Come to my site and we can have a chat.

[@emersonurbina8042]

Where can we buy one of these

[@usbbdm]

Find the info at the end of the video.

[@emersonurbina8042]

​@@usbbdm just ordered thank you can I ask how do I know which wires go to which pin i know the pins were shown in the video but are the wires labeled

[@usbbdm]

@@emersonurbina8042 In the software there is a connection diagram for the BDM connection. You can now download the software and chat with me there.

[@2015_Rubicnn]

Is this the same E40 the 2005 Pontiac GTO uses?

[@usbbdm]

I am not sure.

[@2015_Rubicnn]

@@usbbdm I was loading a calibration and the voltage dropped causing the ecu to become nonresponsive. Is there any way to unbrick the ecu?

[@usbbdm]

@@2015_Rubicnn If the firmware get corrupted, u-Link NT can restore it.