Using Fix-a-floor to fix a loose hollow floor tile in 10 minutes for good.

[@candocan1668]

Thanks for sharing, very useful.

[@JAYBRIAGAS]

Thanks for this useful demo. I wonder how the air goes out? Should it be 2 holes?

[@paulkelley86]

I was thinking that as well, but I followed the instructions calling for just one hole and it was great. I bet the air finds its way one way or another.

[@JAYBRIAGAS]

@@paulkelley86 thank you. Ill try a single hole first. Hope it works on my tiles.

[@microcementlacalamijasspai8269]

I used a diamond bit worked well

[@billkline3002]

I have tiles that definitely need this. But the grout has broken down in some places. Any suggestions how to use without the product just coming straight out the grout lines rater than going under the tile?

[@buildyourownhomecalifornia]

If it was me, I would cut out the broken grout and regrout it first. Then do the fix a floor

[@agogley]

I found that I had to drill multiple holes till I found the one that worked best. Usually running the same direction as the thinset.

[@bhadz100]

Hi what drill size did you use?

[@Legerm87]

He says at the very beginning of the video.

[@stacyadams6408]

Have porcelain tile what type bit would be better

[@buildyourownhomecalifornia]

I used a masonry bit

[@Zoltan1996]

8 mm hole or 6mm can you give me an answear?

[@paulkelley86]

either would be fine. Metric drill bits are not normal here so I would advise more like a 1/4 inch to 5/16.

[@irinaprotasova229]

If my tiles were loose enough to remove, which i did, can i use fix a-floor to just glue it back down without having to remove thinset and all the old cement from floor and tiles?

[@paulkelley86]

It doesn't say to use it like that. I do not recommend it. If your tiles are completely broken loose like that I think I would do my best to break up the thinset and get it as clean as I could, then re-thinset the tile down and grout. It sounds like a lot of work but it wont be that much. You can do it!