Using IR Receiver (HX1838) + Remote Control (ESP32 + Arduino Series)

Control your ESP32 projects with an infrared remote control. They're cheap & easy to use.
By using a remote, you can replace physical buttons, and enjoy controlling your projects from distance.
20% off: Elegoo UNO starter kit:
amzn.to/3cA0cAS
(Code: "SimplyEx" / Available until 11/01/2021)
⚡️Other videos in this series:
• ESP32 + Arduino
(Everything you need to know about programming the ESP32 by using the Arduino Framework)
🌍 Social
Twitter: / savjee
Facebook: / savjee
Blog: savjee.be
❤️ Become a Simply Explained member: / @simplyexplained

[@deepakhere233]

Thanks for this playlist. All videos are small yet very helpful. Best explanation. I couldn't find such videos on KZbin but then came across this playlist about ESP32. Thanks!

[@castrok.8589]

Thank you my friend !

[@antoniomoraes7655]

Hello, the decode command is deprecated... warning: 'bool IRrecv::decode(decode_results*)' is deprecated: Please use decode() without a parameter. [-Wdeprecated-declarations] if (receiver.decode(&results)){ how would be the current correct code? thank you

[@franky201226]

Thanks alot man. 😍

[@TheMoumou120]

hello i got a problem with the readed value i always see FFFFFFFFF on seial monitor btw i use the same code as yours and an 38khz IR rec any propositions??

[@MrCharlieCompany]

How did you flash the board so quickly?

[@Zomwil]

20 seconds is not that fast

[@meanonymous1000]

I am receiving Different hex codes at different distances .what to do?

[@simplyexplained]

Use those instead. Every remote will be slightly different. That's normal.

[@vkp111]

Maybe your remote is faulty. Change your remote.