Although my DRO is the same as yours but a different name I followed your instructions but it did not work. I eventually found that on mine each time you set a new SDM function you have to press enter afterwards. Your video did let me get my head around it though so thanks for sharing
@Everett-xe3eg3 жыл бұрын
Thanks for the video, this is just what I needed.
@samrodian919 Жыл бұрын
Thank you for that. I've managed to get mine set up for a job with a large chunk of cast iron and I've just almost finished the initial drilling of four 6 mm holes, and I'm currently going through up the sizes to 25 mm then boring to 35 mm using this positioning system. Now I know how to set it up it's easy. I have a later ToAuto touch screen unit which is rather different looking but the set up is the same. Bloody introduction manual is totally fucking useless!
@douglasbattjes39912 жыл бұрын
It does work, mine is a Ditron D-60 but they seem to be the same, really like to see more on this unit, really helped out, would it be the same if you wanted to mill a square pocket, and set 4 locations, the same way and just go to those locations or just mark the corners and record on paper?
@gregc1775 Жыл бұрын
Hi Keith Like all your videos very informative. Have a question I hope you can help me with. My DRO on my lathe has the tones or beeps as I press the buttons. HOW do I turn the beeps ON ???? It’s a SINO. But might be the same on other models, Any help would be greatly appreciated. Instructions are no help and neither is Hare and Forbes in Australia where I purchased the lathe from. I did see a video on Utube a long time ago on how to do it but at my age forgot, should have wrote it down. Regards Greg