V8 S10 Fixing Negative Wheel Camber

[@kennethharms7503]

you have no motor in hole it will have neg camber if you put some weight in the hole it will pre load the springs a bit at that time you use your shims to adjust your neg or pos problem . your upper's are almost bottom out from the looks of it. when you get the motor back in the hole you will back in there messing with shims

[@wreckanchor]

So you put 2 of the left side speedway 8 1/2 inch upper control arms on?

[@304customsgarage]

Yes I actually have a set of both the 8" and and 8.5" but currently have the 8.5" ones on there now. Supposedly allows for more adjustment when lowering which I may do also some in the future depending on how it sets. I got the 8's originally and kept them just in case need to switch back

[@nsmturbo5902]

​@@304customsgarageSpeedway says to use 2 rights. You used 2 lefts?

[@304customsgarage]

Yes I used the 8.5 inch ones on both sides.

[@HerringMotorsports]

Are you sure those control arms are on the correct sides?

[@nsmturbo5902]

@HerringMotorsports Speedway says to use two right side uppers on an S10

[@jayinmi3706]

Proforged also makes taller ball joints, and I believe they have boots.

[@jaycar777]

I couldn’t help but notice, the sway bar is still installed. Do I need my sway bar, if I’m only gonna drag race?

[@304customsgarage]

I don't see why you couldn't remove it if you wanted for a drag only setup. I left mine on since it will be mostly street miles the truck sees vs drag strip passes.

[@jaycar777]

Cool deal, thanks

[@TheBlazerSociety]

Love this! Gotta do this for my s10. What was the part numbers for the control arms and ball joints?

[@304customsgarage]

Control arms are speedway # 91031134-L, those particular ball joints are # 91720145-1. The ball joints I don't particularly like the idea of not having the dust boots on them and I would've gotten the afco 1" longer ones with the boots if they had been in stock when I got them but they weren't available so I'll run these for now and see how they do.

[@TheBlazerSociety]

@@304customsgarage ill have to check those out thanks for this!

[@superbeeblaze]

did you really try to adjust all the geometry with the truck in the air? lol everything is going to be way different at ride height man.

[@renwickconolly2839]

Great Content!

[@robertabran3911]

Did you only replace one side?

[@304customsgarage]

No I did both sides just only one on camera for an example

[@D2Offline]

Now put the weight of the motor on it and set it on the ground, then do any adjustments that are needed. I laughed too hard at this video.