Put some stiff foam behind the knob to cause some drag on the adjustment.
@zenginellc9 ай бұрын
If I do this, I may just 3D Print a cover that goes over the POT knob to prevent it from being bumped, then I could just use a flat head screw driver at the end to adjust it. Interesting, thanks for sharing this!
@421CentralIowa9 ай бұрын
The good news is you can bump it pretty good and it'll only result in the voltage chaning .1vdc one way or the other :) This has been a solid performer for me since I got it. The voltage has never changed from 15.0 the entire time I've been using it.
@AltereggoLol14 ай бұрын
how has this power supply held up? I got the 40 amp one, not sure if I trust it anywhere near that output...
@421CentralIowa4 ай бұрын
I haven't had any issues and I've had it powered on continuously since the day I did this mod and it has sat at 15.0vdc the whole time. I am only using it to power two CB radios that draw 8 amps at maximum output. Its typical load would be more like 4 amps when the radio is being used or .5 amps when the radio is just powered on.