VEICHI VFD TWO WIRE CONNECTION AND PARAMETER SETTING.

[@5thgea]

Sir how is the quality of veichi products?

[@gurdassidhu6694]

Low farcancy set vaare dso ji

[@electricalautomationworld.6770]

@@gurdassidhu6694 tell me detail what you want

[@electricalautomationworld.6770]

So I will make video like same

[@Mechanic_M]

Hi. Can you please tell me if I only need to start and stop without reverse, in forward direction, one button (NO+NC) with locking is enough for me? For model VEICHI AC-10

[@electricalautomationworld.6770]

@@Mechanic_M Hi, You can just take either one NO selector type for two wire mode or no nc both with three wire mode

[@Mechanic_M]

@@electricalautomationworld.6770 without fixation? a pulse is sent to the output X1 to start, the second circuit on X1 will mean STOP for it

[@electricalautomationworld.6770]

@@Mechanic_Mthis video describe two wire mode which is giving continuous signal though switch If you want to operate by pulse you can follow three wire mode in another video

[@electricalautomationworld.6770]

Check the another video already in channel

[@Mechanic_M]

@@electricalautomationworld.6770 Thank you for the video. I'll subscribe.) Unfortunately I am not so good in English, so forgive me if there are mistakes in my explanations It was important for me to realize that I can STOP/START just one button from two wires (X1+ GND) to start only in one direction (I don't need reverse). Your video helped to figure it out. Thanks