Thanks Kevin Dwyer for this wonderful presentation, so clear and simple.
@owowaoladipupo32602 жыл бұрын
Thanks Kevin.. Dry seal system simplified. Best presentation have ever seen on this subject.
@johnsmall972910 ай бұрын
Thank you Kevin. Very useful analysis of problems, and solutions too!
@ravir99702 жыл бұрын
Thanks Kevin Dwyer and John crane team for the crisp & clear presentation. Valuable content for DGS users.
@basabroy49182 жыл бұрын
Excellent presentation
@prakashmayyak99162 жыл бұрын
Very good explanation. Thank you very much...
@AnthonyZgheib-l8j9 ай бұрын
Thank you so much for this video!
@666windstar2 жыл бұрын
Thanks for clear important, i have a question utilizing your John crane experience, When using dry gas seal in Centrifugal compressor is mandatory? other than hazardous gas service?
@gee16173 жыл бұрын
tell me what happened when refrence gas and buffer gas difference pressure is high is it damage the seal
@MrAlwinj3 жыл бұрын
useful info
@gee16173 жыл бұрын
tell me what happened when reference gas and buffer gas diffencal pressure is high is it damage seal?
@rareoaq2 жыл бұрын
Unless you exceed the pressure rating of the seal (which is unlikely if you are coming from discharge), a high differential pressure across the process laby shouldn't damage the dry gas seal. It would simply increase the flow through the process laby, up to a choked flow condition.
@MrRaminhodinho3 жыл бұрын
What pressure difference is there between the fluid entering the primary seal and the fluid heading towards the labyrinth seal
@rareoaq2 жыл бұрын
There is no pressure difference in the primary seal cavity, between the process laby and the primary seal. The pressure will drop as the gas moves across the primary seal face and the process laby (or any restriction in a flowing application). The pressure entering the primary seal is a controlled parameter, controlled by the support system to a setpoint in order to maintain a specified velocity across the process laby. The pressure downstream of the process laby is approximately equal to the compressor suction pressure (if the compressor is balanced). The pressure downstream of the primary seal is approximately equal to the primary vent back pressure, which is controlled with a back pressure regulator or a check valve with a specified cracking spring pressure (usually around 5 to 10 psig in normal seal conditions).
@MrRaminhodinho2 жыл бұрын
@@rareoaq thank you that was neatly explained
@MrRaminhodinho3 жыл бұрын
my question again is how is the pressure difference is distributed across the seal
@ashwinnarayan4450 Жыл бұрын
Can any body please send me what do it there is a loss of separation gas during centrifugal compressors operation with dry gas seal system in place