#vevor

Рет қаралды 17,206

Күн бұрын

Пікірлер: 22

@RodneyGracia Жыл бұрын

Gosh. I just returned this. I could not get an accurate cut through a print with two full bleed prints. After 10 tries it simply can’t be that accurate. Ritatrim Pro it is for me.

@nicholasb3122 2 жыл бұрын

Thanks for the video. How good are the cutters? Would this trim card from each side and give a clean edge for greeting cards?

@nicholasb3122 2 жыл бұрын

@@Exploramix Thanks, my card is thicker but I may give it a go as its not that expensive. Did where you purchased also supply replacement parts. I'm thinking I'll probably need to replace the blades often.

@kajo3575 Жыл бұрын

Does that work on cardstock?

@Exploramix Жыл бұрын

Less likely. Max thickness would be like 1mm. Those spinning wheels are quite "fidlicky"

@bickleyinnovations7365 Жыл бұрын

Could this machine be used to crease or score corrugated cardboard to make the cardboard easier to fold?

@Exploramix Жыл бұрын

👍

@perrylee115 9 ай бұрын

Can it handle food grade wax paper??

@Exploramix 8 ай бұрын

For cutting - yes. For creasing - it will depend on the type of the paper, thickness, etc.

@tobylarone3831 9 ай бұрын

could this crease tissue paper without cutting through it?

@Klokopf52 9 ай бұрын

Mine can't, the dies are not ground properly, but maybe with some modifications it should be possible. You'd need to figure out a way to protect it from the rubber wheels as well. Maybe put it on top of a foil or another sheet of paper.

@Exploramix 9 ай бұрын

I don't have it anymore but if I remember correctly, it is possible to adjust with few screws on side the pressure of rollers to some point. However, what could be a problem is a fast speed of rollers and you can't adjust the speed without tempering the electronics.

@Exploramix 9 ай бұрын

It's not a good machine for adjustments and fine work. It does what it does but expecting to fine tune the speed or else is unrealistic. I got rid off it fairly quickly.

@Klokopf52 9 ай бұрын

@@Exploramix what did you replace it with? Difficult to find things like this outside of industrial use :)

@zahoorahmadnoorahmadahmad3206 Жыл бұрын

Available in India?

@Exploramix Жыл бұрын

It should be. Google the word VEVOR creasing machine

@rivertownguitarknobs Жыл бұрын

This is not the correct way to set up the machine. The cutters/creasers should align with the metal rollers in the grooves. The blue rollers should be on top of the white rollers adjusted to the thickness of the paper. Setting the machine up as shown will ruin the white rollers and dull the blades.

@Exploramix Жыл бұрын

Thanks!