Virtual CAN - Configuring ICSim & Identifying Signals

Get a virtual CAN bus set up with ICSim and start identifying traffic with Block Harbor Cybersecurity!
Check us out at: blockharbor.io
ICSim: github.com/zombieCraig/ICSim
Commands:
sudo apt-get update
sudo apt-get upgrade
git clone github.com/zombieCraig/ICSim.git
sudo apt-get install libsdl2-dev libsdl2-image-dev
sudo modprobe can
sudo modprobe vcan
sudo ip link add dev vcan0 type vcan
sudo ip link set up vcan0
cd ICSim
make all
./icsim vcan0
./controls vcan0
candump vcan0
cansniffer vcan0
./icsim -r vcan0
./controls -s [seed] vcan0
./controls -s [seed] -l 2 vcan0

[@ayodejifewa8292]

Thanks soo much for this content.

[@youtubesucks376]

Sweet! Now I can fuzz the bus without breaking my car!

[@bigboss-bv5wl]

which one is the pount symbol

[@bennguyen1313]

Any idea if CAN hardware (Ixxat USB-to-CAN V2, Peak PCAN-USB, etc) will work on a Linux VM running inside of a Windows Host? Or will the Windows driver have issues with passing data to Linux/SocketCAN?

[@tilojavideo]

I cant make my control needle go up. Everything works except that.

[@artsie6146]

tysm that was so informative