Vittorazi Motors V-Tutor - Mounting the air conveyor

[@ryguyfly9171]

Shroud really doesn’t bend that easy. Suggestions? I can’t get this thing over the screws without scraping the hell outta the underside or risking snapping the shroud in half

[@jeffboothe6402]

Note: I had to make 3 modifications for proper fitment of the shroud. 1) The distance between the studs (fore to aft) were greater than the holes in the shroud. I had to warble the 2 aft holes to match the stud distance. 2) Also had use a whole saw to increase the diameter of the sparkplug hole about 1/16". It seems the carbon fiber coating is thicker than the tolerances and the hole is a smidge smaller than would allow a sparkplug socket to enter (tried several sockets). 3) I also trimmed sparkplug rubber ring seal to allow the sparkplug hood to go all the way through it. Otherwise, the sparkplug connector would not completely snap over the sparkplug tip. It still makes a very tight fit around the sparkplug hood and ring opening.

[@dcramsey08]

I had a friend who followed this and the nut came loose and went through prop. Can you please recommend a torque setting and/or instructions on how often to re-tighten these?

[@2AMMEYs]

Nice instructional videos - thanks for the effort!

[@arielmuroarg]

Good video!.. Please, upload more videos like this!

[@clubsnapperuk]

at 2.00, i see you have not used the supplied washers the fit on first -then the rubbers, why?

[@washingtonfly3833]

Quero o meu #Boravoar

[@CedarPass]

Did you fellas add the wrong audio track? It's an obvious copy off the demo's usually provided on sound vendors' pages - AudioJungle, perhaps? When you pay for it, you don't usually get that "AudioJungle" over-dub everyone can clearly hear every ten seconds or so. Otherwise, good instructional.

[@michelfrenk3582]

só eu q ouvi uma voz falando baixinho " corintians" varias vezes ao longo do video ??? kkkkkkk

[@BrendaEM]

If the nylon doesn't handle the heat well, then.... products.coburnmyers.com/viewitems/nuts/stover-lock-nuts These are nice looking engines.

[@JohnHansknecht]

That upgrade is sort of ugly. Does it really do very much to help cooling?

[@ripmanridin7092]

30 degrees cooler.......

[@christianbugarini]

tengo un Moster 185 que No llega a 20hs de uso y SE ROMPIO todo el escape!!! un motor de 3600u$s que es una PORQUERIA!!! Cuesta como una moto y se rompe a las 20hs!!!! Vuelo hace 20 años y JAMAS me había pasado esto...un DESASTRE una desilución de marca. La marca de motores de paramotor mas vendida del mundo y NO DAN GARANTIA: Un desastreeeeeee. A cualquier alumno que quiera comprar un motor JAMAS le voy a aconsejar un Moster o nada de la marca Vitorazzi