Voltage/ Frequency (V/F) Control of Induction Motor - Open loop & Closed loop

This video describes the open loop & closed loop Voltage/Frequency (V/F) control of Induction motor with torque speed characteristics.
Download PPT
drive.google.com/file/d/1MUX3...
Download PDF
drive.google.com/file/d/1p_jT...
If you have questions, please don't hesitate to ask in the comment section. You can also send me your comments/ questions to my mail id - [e-mail]. I will try my level best to answer all your questions.
Pls like, share and subscribe. Thank you!

[@FutureofEEE]

15:12

[@andresyenes7261]

This level of clarity and didactic is what one would expect from a lot of professors. Thank you very much for this wonderful explanation :)

[@mohammedalzahrani4310]

Thank you so much, I’m a PhD student and found these videos you make are really helpful.

[@FutureofEEE]

Thank you everyone. Ill try to do the simulation ASAP. Thanks!!!

[@gspowersolutions]

Thanks for sharing your knowledge and time in making this wonderful video. 😊keep rocking. Subscribed your channel 👍

[@arunkumar.d.gdgak4u646]

10/10 for the Video

[@alexandercastaneda9431]

Thank you

[@manishkumargupta8677]

really helpful videos sir.

[@Yalla_Balaji]

It was a great video and your voice is clear. Hope a subscriber motivates you

[@alagarsamy3914]

Brother I got a good information… thanks

[@marcosaudomaroquirozpina561]

alguien me puede decir que es esa p de p/120 ?, no entiendo que es lo que dice

[@manalikolekar8094]

very nice explanation

[@mehdinikoozad7068]

Good Job 👍

[@willyc2685]

sir, why after PI controller, the error becomes slip-frequency?

[@mohitnair6871]

I would like you to put up a video series of complete closed speed control of IM3phase both hardware and software..

[@shubhranshuranjansharma4892]

Sir you explained very well, if you do the simulation part ,that will be great and more understandable

[@afsalm1611]

outstanding

[@mt-gaming9547]

Sir I have a question: In the closed loop why the input of the PI block is N* but the output is F*?????

[@rebelarvind9414]

hi bro, when will you be doing the open loop and close loop control of induction motor? I want to check how draw 1kw power hybrid wind solar to induction motor , so far i did resistive load as an output , how do i change it to induction motor with 1kw?

[@SantoshYadav-Bgm]

do a video on sensorless v/f control method