mynetworktrain... - In this webinar I will explain about VRRP protocol and will apply VRRP to run on MikroTik routers. Follow me: Facebook: MaherHaddadOfficial Twitter: Mynetraining Website: https//mynetworktraining.com
Пікірлер: 20
@vinyloquino72764 жыл бұрын
very nice presentation. thanks for this information ideas.
@masterdaweb14 жыл бұрын
Thanks for sharing this Maher, very good tutorial. All the best.
@dvreshta4 жыл бұрын
Nice presentation. Thank you Maher
@Manga-20994 жыл бұрын
Very informative, thank you!
@patriciowallace4463 жыл бұрын
thanks, Is possible to work also to have different ISP ?
@BekoIQ4 жыл бұрын
we are waiting the second video about if we have problem in wan interface
@md.mijanurrahman83443 жыл бұрын
Mr. Maher plz explain ... if R1 or R2 router uplink down what happens ???
@Triyugo4 жыл бұрын
how long will it take, if it loads a lot, phone conversation broke up
@forex-chart-analysis-daily4 жыл бұрын
sir if i have 2 diffrent isp connection i can configure it?
@NarootW4 жыл бұрын
If we open the mac address table on router 1 what will we see the mac for the virtual IP (10.0.123.250)?
@excession12934 жыл бұрын
Each VRRP interface gets its own MAC address.
@jimmertzos39674 жыл бұрын
I have Vlans running on router R2. and i want them to run properly when interface eth2 on R2 malfunctions. what can i do?
@excession12934 жыл бұрын
You can either configure VRRP interfaces on top of each VLAN interface or you can configure your VLANS on top of a base VRRP interface. I prefer the first option because it gives you the most flexibility.
@jimmertzos39674 жыл бұрын
@@excession1293 thanks will try it this weekend :D
@rizvifrombdesh88352 жыл бұрын
what about grrp, it's the better option
@MAICT2 жыл бұрын
not available on MikroTik
@alierphani66814 жыл бұрын
can you make Wan fell over please
@excession12934 жыл бұрын
Hi, thanks for this training. On the Mikrotik man pages it states: “address on VRRP interface must have /32 netmask if address configured on VRRP is from the same subnet as on router's any other interface.” wiki.mikrotik.com/wiki/Manual:Interface/VRRP#IPv4 Can you please explain why your configuration didn’t use a /32?
@excession12933 жыл бұрын
@Michael Braun This is what I thought too. I was hoping Maher might correct his video or put something in the description.