Vulcan 750 Jetting and Slide Modification

[@Ева.Пикачу]

Короче, пацан убрал штатные воздушные фильтра и заморочился КИТом. Поставил два нулевика и наковырял карбы. Что-то там с жиклерами накрутил... 2 размера 47-48 и 42. Я в аглицком не очень, да и жует он что то вроде) Вот с иглой я не понял. Рассверлил что ли? Хотя там таблица в конце, иглу походу приподнимал: На 3 шайбы и на 1. Ну замеры выдал. И размер жиклеров. Но, говорит, прёт моцык.

[@dylansmith3]

Really gotta thank you for the vid, not sure if I’ll cut the hole for the needle at first. But found the DIY online mentioning the 142 main and the 42 pilot. Hoping that helps me idle better and not run lean. You should make a video on installing the A/F gauge and O2

[@Outlaw939]

Your motor cycle is so cool

[@Diebesten162]

Do you remember what kit you used for the fuel air sensor? I have the same bike and That would definitely be a nice to have for me

[@eldarkafarov2322]

Did you get rid of the emission crap? If yes, do you have a video or at least some instructions?

[@kingsolomon4392]

is the vacuum line for the petcock getting pressure to the tank, or sucking fuel down into carbs?

[@hundleycycleshop8876]

The petcock is vacuum operated. They do this to insure that if you have a sticky float that it does not flood the engine with fuel when the engine is not running and you forget to turn it to the off position. When the engine is running it supplies vacuum which opens the petcock and allows fuel to flow to the carb.

[@neilbrown82]

what size Jets do you use re jetted mine but two shims under the needle and I don't have a lean condition and seems to run great

[@BriggsHandyman]

Do you have a video on removing air box

[@hundleycycleshop8876]

I sure don't. To be honest with you I used a Sawzall to cut it out. I had no plans to use it again, cutting it out was quick and therapeutic. No longer a struggle to get the carbs in and out or to remove the engine.

[@Canadian_Craftsman]

​@Hundley Cycle Shop did you have to "sync" your carbs or no?? I'm about to go through with this already did the exhaust pod filters and block off plates!!✌️💚

[@danb.3397]

Good info but man, get to the point. Probably 3 minutes of hemmin' and hawin'.