Volkswagen Golf MK6 2012 1.4 TSI | EA111 | CAVD 160 HP 6 speed manual transmission.
Пікірлер: 44
@robinmundell87235 жыл бұрын
Great video - did the trick for me on the rear door trim. Just have to remember to leave the inside rubber seal dangling untill the trim is in place and then hold glass and squeeze the rubber down between window and new trim. Thanks Vlad!
@BigBoll4 жыл бұрын
You welcome Robin! Appreciate it! ^_^
@johnp2112YYZАй бұрын
used similar tactics for 2004 Beetle, spot on 🤙
@rachidijja94817 ай бұрын
Merci pour ta vidéo grâce à j'ai pu faire le nécessaire pour les plaquettes de frein de ma voiture et éviter de sortir les sous sous 😅. Si jamais tu as d'autres vidéo ! Je prends 😊
@robertmende37934 жыл бұрын
I had a bent pillar and top moulding in the rear window of my 2010 VW Jetta caused by an accident with the previous owner. The bent pillar allowed air to whistle through at high speeds. While it has performed as a good commuter car, it really wasn't worth it to put a lot of money into it. With the help of your video, I was able to remove the pillar and trim and found that the steel flange holding the trim at the top of the door was bent. This caused the trim piece to bend downwards and create the open hole. All I needed to do was straighten out the top flange with a few taps of a hammer, then reshape the pillar and put everything back together again following your instructions. It cost me nothing! I wouldn't have attempted it had I not seen your video! You have saved me time and money! Thank you, Vlad!
@BigBoll6 жыл бұрын
Haven't seen a detailed video on this topic so I decide to make my own one! Hope it will be helpful!
@Xbot4Life5 жыл бұрын
Have you got one putting it back?
@AlmostLastJedi3 жыл бұрын
3 years on and it’s helped me immensely👌😎
@grecziadrian3881 Жыл бұрын
Thanks for uploading! I've been looking for this everywhere! 🙂
@christchurchboy3 жыл бұрын
Great video! sliding the glass channel rubber back is a bit of a fiddle, when you come to put everything back!
@rodpetrie10883 ай бұрын
Excellent, great video demonstration.
@silvioroesler82844 жыл бұрын
As clear as it gets - thanks for posting!
@DJEDS2 жыл бұрын
Great video. Thanks for taking the time to show this. Do you have a video of you putting it back together again?
@paulagnew81302 жыл бұрын
saved me so much time ! i thought they where stuck on !
@isrraelmoran3096 Жыл бұрын
Muchísimas gracias tu video me sirvió un montón.
@litl4574 жыл бұрын
On my mkv Jetta had to remove the inside front door panel and the window inside sweep moulding. I have a picture but don't know how to share it on here?
@jasonkieswetter26672 жыл бұрын
I was unable to get the side wheather stripping back in and had to cut the lower portion off to get the window closed. Now I need to take it to a shop and have them replace the seal.
@Anyman19835 ай бұрын
Can we have a video on how to put a new one in after removing the old one please? Anyone know where to buy a replacement? Cheers!
@user-tp7mv7qq6j6 жыл бұрын
You Fkin legend thank you.
@BigBoll6 жыл бұрын
You welcome dude! )))
@danielfl.93474 жыл бұрын
Thanks. Is it the same on the MK5 3 door?
@rupertridout-jamieson855 жыл бұрын
Off to but some new trim to replace rusty existing. Ta very much for methodology
@mihaitanasescu6128 Жыл бұрын
Any idea where I can find this piece for a Tiguan 5N from 2015?
@omererdogan72159 ай бұрын
Thanks 👍
@litl4574 жыл бұрын
Mk5 Jetta is similar, rear door panel is easy, but front panel is a bear to get the rubber back in there. Have to take the inside door panel off. Is there a easier way?
@clxboxone4 жыл бұрын
man you saved me some money :)
@dyasar885 жыл бұрын
Thanks, but I can't get the rubber bands back in... Now what?
@mmat82085 жыл бұрын
Leave the bottom trim off and insert the rubber on an angle to miss the window regulator mechanism below. Don’t be fooled thinking the window up/down will help. Or, using any type of lubricant.
@BigBoll5 жыл бұрын
Just try to guide them with a thin metal stick (the way I have done it).
@IosephusVarisque4 жыл бұрын
Thank you soooo much
@smaloner5 жыл бұрын
How in the heck were the screws that easy for you?! I stripped 2 then gave up for the day
@jessicah34504 жыл бұрын
Did you try WD-40?
@Rocky71814 жыл бұрын
Jessica H I think I might have to use it once u put everything together
@christel31024 жыл бұрын
You made my day! thanks :)
@BigBoll4 жыл бұрын
You welcome :)
@RidiPwn6 ай бұрын
now how you put it back lol
@Fily204 жыл бұрын
Where i can buy that piece??
@SicaMarius235 жыл бұрын
Au ceva cod pe ele :D sau stii codul lor?
@melissamcclay48023 жыл бұрын
Same for 2007 Vw Jetta????
@tomasespana7799 Жыл бұрын
can someone please tell me how to build the seal back ? i can't haha