Walt's a professional. I'm a hobbyist. I just load the tube with epoxy with a Q-tip, then coat the rods going inside it with epoxy and cover both ends with painters tape. I do use the little piece of tape around the rods but I place it in the center, not on the ends. It keeps the rods centered inside the tube if they are just a bit undersized.
@Every1Has111 ай бұрын
On a budget ..Brake bleeding vacuum pumps will work 15- 20 bucks.
@mikeredrugger11 ай бұрын
Can't wait to give this a shot
@donscottvansandt413911 ай бұрын
Awesome stuff!
@johnvanderwalker483011 ай бұрын
A break bleeder pump can work too.
@danwerkman11 ай бұрын
I must say...the ball bearings are a novel idea. Always innovative you are.
@RinaldoFamilyMetalworks11 ай бұрын
Was you Kydex vacuum DIY? If so, have you made a video on that? Thank you for the educational information!
@ryanblystone515311 ай бұрын
Thank you
@sween18711 ай бұрын
If you do use a syringe try using a smaller volume one 1ml or 2ml syringe this way you can get more pressure compared to a 10ml 20ml syringe
@Dreweldeenknives11 ай бұрын
I have a Milwaukee pump battery powered that’s a sweet tool
@xthemadplumberx711011 ай бұрын
Watching and I see a vacuum pump and I cringed; I’ve been through two stabilizing. My wife said I’m done buying them. I’ve been told that a brake bleeder from Harbor Freight will do the same job; I have yet to try it.
@larrybud11 ай бұрын
You also don't need to just fill the tubes with metal! Small dowel rod of your choice of wood species!
@ozarked236310 ай бұрын
The first one I did I used an aluminum round tube with a brass square tube inside it. I wanted something else inside the square tube and realized that a round toothpick fit perfectly snug inside it. A little black epoxy around the toothpick filled the corners of the square tube. I used the pins on a camp knife for my SIL with mahogany scales. I also once used a .223 case with the neck and base cut off for a lanyard tube.
@andrewsteinberg710311 ай бұрын
No way would that work for HVAC in Ac pump downs we use two stage vacuum pumps and they’re like at least 50 pounds in weight
@billwoehl305111 ай бұрын
You could thin the epoxy with acetone, but, then it would just drain back out of the tube after you took the vacuum away.