Was the problem this simple?? Acura tl type s Receives some long waited care

Рет қаралды 5,910

Күн бұрын

Пікірлер: 46

@No_Transitory 4 ай бұрын

I was able to turn my wheels to remove the plastic wheel well and able to get to the main bulb on the headlight without having to remove the entire bumper.

@Stay_positive_Test_negative 11 ай бұрын

Damn we almost lost bro not even 5 minutes in the video 😂😂 but aye good shit!🤝🏼

@premiumlifestyledetails 11 ай бұрын

twass a close one!!

@tankmango757 11 ай бұрын

Dang you were lucky when you worked on the passenger side headlight. I just did mine two days ago and swapped in some AKKON ones. My metal bracket with the two bolts behind the windshield fluid reservoir had this bulge pointing down which blocked the two bolts where I can't fit any sockets. Had to use a small 10mm wrench and loosen it by 3 degrees at a time until I can barely loosen it with my fingers lol. Decided to not put the metal bracket in. Also if some of you reading this have your front bumper not clipping on if you removed your headlights and etc, if you made any changes with the metal bracket under the headlight with the metal clips and where the plastic clips screw onto the side of the metal bracket, you have to loosen the bolts of the metal bracket to their original position before you messed with the headlights or brackets. What I did was loosen the bolts of the metal bracket with the clips and pulled it out towards the front and side of the car so the bumper can clip on the metal brackets. Because before when I tighten the metal bracket, it was pushed in a bit too much and the clips from the bumper couldn't reach. If you are not replacing your headlight assembly, remove the headlight with the metal bracket still on. If you replace the headlight that came with no bracket, this should help you if you have issues.

@simp-sons2354 10 ай бұрын

I finally got a type s 🎉

@MiguelSanchez-tq7sn 10 ай бұрын

I had the same problem with my tl but I change the spark plug and the fuel injector and everything is working well

@robbym3542 9 ай бұрын

lol, the hood struts are on upside down. The hood should slow down as it reaches the top.

@MrShetal69 10 ай бұрын

Please don't use felpro gasket. It will start leaking again under 30k miles

@armvndo6644 10 ай бұрын

The tl headlights have fuses for low beam and high beam

@vijaywright9122 3 ай бұрын

My tl doing the same thing

@osm2757 11 ай бұрын

What about the Bank 1 P0171

@mugensohc2.271 9 ай бұрын

W big brother forsure !

@nickytv5471 11 ай бұрын

You caught bank 4 in time before the spark plug ejected itself i had the same problem and i had to get a temporary fix on the threads for where the spark plug screws into until i get a chance to replace the cylinder head

@jasonhamilton258 11 ай бұрын

Always have Spotter

@Diznyc 11 ай бұрын

Literally W Big Brother Foreal! Hahaha glad to see the TL getting its maintenance taking care of, little bro definitely got to be on top of it! Hope ya are doing well 👍🏾👍🏾‼️

@TheLifeStyle6 11 ай бұрын

yup yup!! hopefully we can keep her in check

@kingjace4 11 ай бұрын

Yeah I need to do better, I just give him money he tells me what to do

@bobbycurrie2997 11 ай бұрын

Rear main seal leak

@Master_Mayhem_Official 9 ай бұрын

W big brother. I’m the big brother in my family and I wish I had you as my older brother to help me with my TL 😭😂 you basically have tho anyways with all your videos. I just follow step by step what you did. Mines only the 3.2 base model but almost everything is the same in terms of fixing them

@TheDerrty111 11 ай бұрын

Just due a tune up and do a valve adjustment. Replace the valve cover gasket along with the plugs seals. Ngk spark plug 6994 is pregap to.44 .running lean is probably your Air/fuel Ratio sensor

@julienf9039 10 ай бұрын

Thought to get oem coil packs but they're crazy expensive. Which do you recommend?

@TheLifeStyle6 10 ай бұрын

I recommend the ones I got

@TheLifeStyle6 10 ай бұрын

P2R racing

@uclidsylvestre4757 11 ай бұрын

I have those 2 exact lean codes. Did yours go away? Weird thing is my check engine light for those codes come on and off randomly.

@jasonhamilton258 11 ай бұрын

On the headlights is that the hint of blue with white or is that 8k blues definitely ordering set just not sure which ones i want some blue in them maybe just go with all white with hint of blue nice lights tho. You're content is awesome thank you 😊

@jackanthony7786 10 ай бұрын

Have you ever had issues with your clutch pedal? Mines been sticking but no leaks and I can pull it back up and keep shifting fine. Was thinking it’s a clutch return spring above the pedal

@zachwilder6706 11 ай бұрын

What a good brother

@kingjace4 11 ай бұрын

Yo shoutout to big bro, always got my back💯

@jo3lo85 11 ай бұрын

The igniter is the issue for the light not turning on 😊

@benjamincainesr.6280 11 ай бұрын

"W" for the Big Bro!!!

@TKAutotechInnovation 11 ай бұрын

Big bro FTW !!

@ezioperdomo3115 11 ай бұрын

Idk my tl has a sound that just sounds clogged it’s underpowered,sometimes il hear a rattle but only in gear ….literally happened of nowhere even stalls at times

@trents2781 5 ай бұрын

Any update I have same problem

@TgAzariah 11 ай бұрын

Bro my brother got my other brother another type s so now im in possession of 2 type s now, it really do be like that huh

@Ethanjdanh 11 ай бұрын

Do you have a type s rear lip for sale and will ship?

@niabingie7785 11 ай бұрын

You need to clear the codes

@felipevaldez4983 11 ай бұрын

Nice Job!

@AdnanSkillz1234 11 ай бұрын

nice vid. tl gang

@Sanjko87 11 ай бұрын

You got to be kidding right ? You have to take that much just to replace a headlight bulb 😮

@TheLifeStyle6 11 ай бұрын

Yes fr lol I’ve seen ppl do it through the fender wells but that’s only if you have AF intake on driver, either way I can’t fit in there to work without risk of breaking the light.