Way to change the PRESET value of Timer from HMI during run time in ENGLISH

[@irajnoormanesh9805]

God bless you

[@landarful]

How can i pass the value of the timer preset value from HMI in STRUCTURED LADDER/FBD as input in function block.

[@vinoshan1988]

Good bro, super learning many things from you

[@logicalsupportandsolutions7741]

If you need any topics comment below bro

[@vinoshan1988]

@@logicalsupportandsolutions7741 Actually I have lot of questions 1. We have a computer program (.net) which is act like SCADA which need to be modified, we used Micro Logix - AB plc, We don’t have that programmer support, So not able to do anything. after watching your videos, I thought Add an additional SCADA program (In a separate window) for the required modifications, Will this work? One PLC two SCADA program? 2. Please post the videos for using PID controller programming for Proportional clamping, I.e. We are the manufacturer of Refinery valves, for leak testing purposes used water pressure in the testing stands, to this test valves are to be closed on both ends with hydraulic pressure, this hydraulic pressure must be higher than the water pressure, which means two pressure can be raised, One should higher than other & The different not to exceed more than 100Psi. 3 How many i/o available in SCADA system

[@logicalsupportandsolutions7741]

1. which programmer support you don't have either .net or AB? 2.if you use two different scada for one PLC is not cost effective. 3.you can use multiple PLC in single scada is a cost effective thing.4.may I know what is the maximum PSI that you are going to use. 5 do you speak tamil? if yes mail me at [e-mail] i will give you a whats app no...

[@yusuf8970]

Hello, I am Usuf from Uzbekistan When I turn on the HMI, the timer is again at zero How can I make the HMI timer keep the last set value after you turn it off and then re-enable Thanks in advance if you help

[@anandhababu1995]

Good work keep it up brother

[@logicalsupportandsolutions7741]

Thanks bro😇

[@kumarkumar-ij8pb]

Super instructions

[@MuhammadArslan-vl7ln]

Sir how to show motor rpm in Delta HMI. I have Delta PLC ES2

[@logicalsupportandsolutions7741]

For that you need to calculate RPM in PLC program then only you can view the speed in HMI

[@logicalsupportandsolutions7741]

You can also use speed instruction

[@MuhammadArslan-vl7ln]

@@logicalsupportandsolutions7741 how to calculate it in PLC

[@logicalsupportandsolutions7741]

@@MuhammadArslan-vl7ln please refer SPD instruction in WPL software

[@MuhammadArslan-vl7ln]

@@logicalsupportandsolutions7741 Ld M1000 SPD X0 K1000 D0 Is it correct?

[@SelvaKumar-dv3sh]

Bro hmi use panni audio, video connect Panna mudiuma sorry thappa ketruntha mannikavum na hmi home erukku athan kekren

[@logicalsupportandsolutions7741]

Bro you can play a small size video By adding video to the program For example (GIF )