Week 9 Electrical Exam Prep Video Series, Journeyman and Master Electrician Exam Series 2017/2020

[@joshuafrank9084]

your videos are amazing.... Very detailed, you cover all confusing concepts perfectly . I wish I found them sooner, Thank you!

[@steveterry54]

After I finish this course, I plan to spend a week or two going through some practice exams, then take the test. My goal is to take the test before the end of February this year. If I had to leave my state, I'd move to Texas.

[@Electricalexamcoach]

You can do it!

[@charlesaverette7560]

Adjust before correcting

[@ryanw8203]

What if the wire type is not listed under the 90* C column? or what if the test asks for an adjustment for a wire rated 75* or 60* ? or what if its asking to adjust types TW, US or MN?

[@juniorfigo]

I have the 2017 Codebook, in there you can refer to Table 310.104(A) thru (E) that explains the maximum operating temperatures of different Conductors

[@SayMore11]

strange that my UL listed romex NM B 6/0 cable isn't listed in my 20/20 NEC book.

[@TheeAMPchannel]

Tuesday! Mansfield,Texas to work at Klein Factory.

[@Electricalexamcoach]

That's awesome!

[@carbq5280]

Took my first test 2 years ago, failed it and took it again 1 month later I decided electrical wasn't for me anymore and walked out like 5 minutes into the second try, I never studied or prepared in anyway until now.

[@Electricalexamcoach]

You can do it bro! electricalexamcoach.com

[@dorianpadilla9338]

U the goat!

[@franciscoherrera3780]

HI SIR .WHAT ABOUT ROUND UP THE NUMBERS

[@arnieselectric007]

Hey Perry, I'll probably schedule my Master's test middle of April...and Tennessee maybe around Savanah or Dyersburg, not sure yet...also, would like info on Electrical Inspector too...

[@Electricalexamcoach]

See you at the top!

[@ammaraldulaimi3237]

The examples for more than 3 conductors adjustment said the size of the conductor then said installed in a pipe with 3 current conductors doesn't that make the total 4 conductors ?

[@DanielaHotea-m9q]

For the question regarding #10 wire THWN-2 with ambient temp of 142- if following the ** next to 10 on the amp table it states to follow 240.4 D which states after temp correction should not exceed 25 amps, does this not apply to this question?

[@texasdailytrucks8165]

When doing the question about 142F THHW on the code book 2020. THHW it’s on the 75 degrees Column and 90 degrees column. Why you choose the 90 column instead the 75? Did I missed a step?

[@Electricalexamcoach]

For derating you will use the 90° C column as long as it's listed in there even if it's listed in both

[@dicknastee1652]

What's the situation where your Ampacity is divided by the bundling adjustment and or correction factor??? Ex: 44A/ .91 x .80….. conductor sizing??? Examples please. Thanks