Do you have a video explaining the axials ? I’m learning on a power at 1500… Thai you
@jefferyd4194 Жыл бұрын
Yes I work at a mill we specialize in reclaimed lumber we have a weinig unimat I'm curious a to where is the cheapest place to buy replacement feeder heads and how to u adjust the height of the last two out feed rollers were always having to smack the lumber to get it to feed and it just doesn't seem wise to do so
@RaymonDrawmer6 ай бұрын
If you are having feed problems you need to check that the pressure pads and fences are set correctly. It could also be that you your timber is wet which will also cause the timber to stick. Finally check the condition of the feed rollers.
@chaosalmighty83983 жыл бұрын
I am looking for the best mounded for running mdf molding and rail stock and how many feet per minute will these molders run
@codeev405719 күн бұрын
Weinig moulder lost all power today during a run. Mill breaker blew a fuse, got that replaced. Now moulder is dead in the water, and its all my fault... anything simple I should be looking at that can get me up and running?
@chaosalmighty83983 жыл бұрын
This is for running MDF Rail Stock for custom cabinet doors
@MsJmo1910 ай бұрын
How do I schedule a visit?
@JohnDesMarais-k5z Жыл бұрын
how many knife heads are being run typical 4 5/8 crown total numer of knives for this profile looking at tooling costs
@joshuapatterson633011 ай бұрын
What does your crown look like?
@LawrenceLewis-l3m Жыл бұрын
Does the pressure shoot have to be the same level as the chipbraker
@joshuapatterson633011 ай бұрын
Actually no. Because the board thickness entering the top head will be thicker then the board coming out.
@arielmartinez72263 жыл бұрын
¡¡Hola, deben de subtitularlo para Argentina!!
@thomaswade5783 жыл бұрын
What causes snipe at the end of the product?
@WeinigHolzHerUSA3 жыл бұрын
A host of variables can result in snipe. The key is to control the flow of the board with through the entire machining process. The pressure shoe and chip-breaker are important elements to set correctly and will reduce the risk of snipe on the end of the board.
@timw.39882 жыл бұрын
It depends on the where the snipe is...top, side, bottom? If it is on the side or the bottom insure your tool is straight edged in alignment to the following fence or table plate. Make sure your fences and bed plates are not too far apart. If it is on the top you may have the top chip breaker too tight going in to the cutting spindle, this will cause a springboard effect. Also, insure your drive rollers are all the same diameter...if not this will cause gap between parts contributing to springboard effect so make sure infeed material goes in back to back.
@amitabb34bachanramtr612 жыл бұрын
I'm carpenter machine operator
@cheetahsayz450 Жыл бұрын
need help snipes top and bottom of the
@cheetahsayz450 Жыл бұрын
board
@dankel159 ай бұрын
Top snipes can be a not enough pressure on chipbreaker, gapping, or your pressure shoe/chipbreaker are too far away from the cutterhead. Bottom snips are due to either a pressure shoe not parallel to the bedplate or the bottom head is either too high (tail end) or too low (lead end + chatter)