Wet leg level measurement using DP transmitter | | closed tank

Dp level measuring using dp transmitter for steam... explain the calculation of finding LRV and URV.... Explain condensate pot... and using condensate pot and filled liquid low side impulse line .... and this method is for wet leg calculation..
wet leg level messuring #dp level transmitter

[@CATips]

Explained very well ....

[@creativeeee]

nice and so informative video

[@athilaldurry5880]

Good information, many thanks

[@tannguyen8326]

Sir i have a question, condensate pot is wet leg

[@iinkw7028]

Thank you for sharing, i have questions.. What happen if Condensate Pot line charge in HP side and LP side charge on the bottom ?

[@Techviewautomation]

LRV and URV need to re-calculate and configure..

[@iinkw7028]

@@Techviewautomation How mr/mrs, with same equation?

[@Techviewautomation]

for example LRV=HP side pressure - LP side pressure LRV= IMPULSE LINE HIGHT* x sg - Min Hight x sg =5000-0 =5000 *because of transmitter HP side change to condensate pot impulse line. You can find the URV also same way Thanks

[@baffoxxx2117]

Good morning, is it possible to have the video with English subtitles? Thanks

[@Tahir9419]

why are use glycol in DP Level Transmitter

[@Techviewautomation]

glycol has high boiling point .it does not evaporate easily. So glycol avoid the calibration error .

[@hareem0305]

Worst possible audio translation