What is a Battery Management System?

[@PulsechainProfits]

justin trudeau is clearly a man of many talents.

[@planetmoving9180]

Yes, but this look alike sells bMs, rather than plain BS.

[@splineMerl]

I was about to say that 😅😂😂😂

[@jamez1224]

😂😂😂

[@worldinandaround]

haha

[@CosmologDiraEinstformula]

Ur geniune comedian😂

[@louisbrai2822]

This is so amazingly well explained. It gives a short simple overview of what a BMS is and how it works without compromising on any vital information. Very well done

[@TheViru123]

Dear Mr. Eric, Thanks for presentation, your video is very simple and effective about BMS.

[@deano91062]

Totally agree

[@zafarakber2230]

What a great way to explain to a beginner. The concept is very clear with this presentation and will help understanding the next levels. Thank you Sir

[@thehebrewmessiahcom8164]

Thank you. One question please, when the BMS terminates charge or discharge states, in a cell, do the other cells, combined, continue functioning at a lower capacity? Or does the system just shut down as a result of that 1 bad cell? I'm sorta new at this. Thanks again.

[@kihelsifeddine7802]

Dear eriik, Thanks for the simple and clear explanation, well done 👍

[@TheHowmyable]

Thanks for the clear explanation, it turned out very helpful for my thesis!

[@badrel.192]

Very simple to introduce the BMS. Great presentation !!

[@nicksalonique]

Simple and well explained, thanks a lot!

[@MrBambalan]

Easy to understand presentation. Well done Erik.

[@jeffsit_davidli.333]

Hi Erik, when the battery pack is not on a load (not connecting to any appliance or device) or even charging, will the BMS be still working automatically to balance the cells ? the cells will discharge themselves over time, not sure if the BMS still detect the pack and start balancing according to the cell parameter. Thanks !

[@chenemily6088]

very clear explanation video ! Thanks a lot!

[@rajasharma7577]

Hi Can u tell me how to decide what should be balancing current according to the capacity of the cells?

[@beulahakindele9990]

I will make a playlist if you don't have one!!!! This is so great!!!

[@williamkapembwa458]

Simple explanation but powerful. 🙏

[@SystemHacker23]

does the BMS limit what the battery pack's max pulse draw is or is it separate?

[@sudheerkumarogeti7687]

Very Nice Explanation. Lots of information. Please do more videos

[@EGbattEnergy]

Very good lesson for BMS knowledge

[@asmashakir9484]

this is the best explanation on bms....

[@tonymunn]

Excellent video. Thank you.

[@chrislincoln489]

Question. I have a 4s 12p pack with a BMS. Here is my question. If I connect the leads to each row (4) they monater each row but what each call on each row. There no way they are checked,Right. Thank you

[@昱彬蔡]

Hello, How to solve cell unbalance? Is there any relevant introduction in this regard?

[@PeterOrrick]

Can I connect the battery directly to the hover board, bypassing the BMS?

[@lilidevinefem]

Finally someone else who explains this

[@borkostolo9196]

Great presentation. Very articulate clean.

[@anashussami3689]

Thanks for the clear explanation, your work appreciated

[@potelbat]

Do we have a full circle recycling system?

[@arcoenen]

what's the song?!

[@milan2931]

Is there a BMS 16S in your plan for LifePo cells for HV battery design?

[@RaymondVaughan-m3c]

What is a comms. Interface?

[@shakarhussain3632]

Excellently explained

[@billligon4005]

So what Smart phone app can access this information? How is connected?

[@meisievannancy]

Good explanation. How does one bypass a BMS and charge a low cell via current controlled power supply at say 20% of the Ah rating rated current.

[@OlympusHeavyCavalry]

Why are the outputs based on algorithmic averages as you have stated, and not actual readings?

[@Free__Speech]

Things wouldn't exist without electronics

[@-4kt]

why is the gnd of the slave of the two integrates connected by the daisy chain connected to the last cell of the master

[@speakersubject554]

Hey there, my skateboard BMS is clearly the issue because it is not safe or reliable. Idk whether its the BMS or a bad battery cell. But if you could please help. I'd be grateful.

[@We-Do-NOT-Consent-303]

Hi, I have a left over 48 volts BMS and charger from an E-bike. And I wanna use the 58 Volt charger to charge a 24 Volt 18650 battery pack. Can I use half of the BMS to charge the smaller Battery pack???

[@prasuRangoli]

Wt is galvanometer resistance in BMS

[@carlosreyes6448]

What does charge and discharge mean in a bms?

[@saifsyedmohammad3769]

I want to charge 12V lithium phosphate battery with a charger or power supply especially fast charge with 100Amps that can take energy from Mains supply. How to select my power supply ?

[@dikkospeakerscompany8713]

Great , thanks for this , clear classes

[@Hhtfvhrcbgrejkkjhffvbhb]

Sir, charger why not on without bms?? How to on for testing without bms??

[@AudX]

SOC is taken for System on Chip.

[@danward6420]

Thanks for doing a great job of explaining what the BMS in a battery pack does.

[@krishnagupta9667]

My 17s battery pack is not charging above 69v I have series 13s and 4s bms There is a bit of unbalance in the cells about ± 0.05 volts Also the bms cuts the power at only at 61 volts about 3.56 per cell Please 🙏 tell me the reason so I can repair it (About two times the positive and negative terminal also get short fow a few second with bms installed)

[@asiyahhanifah2094]

Great presentation ,

[@zle5909]

Thank you! Very Helpful

[@MrSchnickel]

this was a well presented explanation and i greatly appreciate it. i do have a question. can the leads of the BMS be connected to the plus or minus on the batteries. the info i have it should be the plus side. however overkill BMS is using some plus and some minus connection. do u have some inside? thanks for ur time

[@vaibhavharde6948]

Which language used for this project , pls tell me

[@wasiuirawo1383]

How can we get it

[@ashrafkassim2688]

Very good presentation, thank you sir.

[@holzwurm_hd7029]

So if i were to replace a battery woth a max charge Voltage of 8.8v with one that has a max charge voltage of 8.4 the BMS would basiclly think the battery is older and not overchage it?

[@danobonano1315]

I'm rebuilding a 15s2p battery pack, can I replace the original 30 amp bms with a 60 amp bms? Thank yu

[@ManuEnduro]

Hi Erik, great videos! Can you also explain how an I²t counter works? I understand it is like a bucket that fills up. How does it empty itself?

[@ritapedrorp490]

Really good vídeo :)

[@psujith9300]

Wonderful video sir

[@Mikeb8134]

I'm very new to ebikes. If you have 10 seconds I have a quick question sir; if someone was running 2 hub motors and their combined max current from the controllers was 60 amps, and you used a battery with 50amp BMS (52v 20ah), what would happen? If you ran WOT you may trip the BMS of the battery and it come back on after a few seconds? Or something worse? Thank you!

[@richardphillips2405]

Thank you for your video. Great explanation for how a bms works. I am wanting to learn how to test a battery pack that won't take a charge. Is it a bad battery or a bad bms? Can the bms be bypassed to see if the batteries in the pack will charge directly?

[@SonuKumar-ot5px]

Sir I have a question I have li ion battery pack with making it basic bms which is comes from chine In this battery pack I tested on aging machine it is goes upper voltage 39 volt to sharp 54 volt when I charging my battery pack having nominal voltage is 36v/10ah what is the reasion behind it

[@TheHumperdebumper]

Very clear, thanks a lot!

[@tmntgamingchannel287]

please Matlab Simulink also added for BMS.

[@vamsikrishna5391]

Very good explanation sir

[@shithinkv7391]

Usually master disconnect possible at negative side

[@saraali-kx2mo]

Best explanation!

[@alexyap7323]

We are building our EV Motorcycle.. we need this. Educational.

[@manishjaiswal3523]

why is there a 400-500% price difference when we go from cell to pack level?

[@tr-GoodVibes]

great explanation

[@snehalraj7309]

I am an engineering student from India. i am looking for a proper BMS and also the most reliable battery that my team NIRMAAN HYPERLOOP can use in our boring machine and the hyperloop pod, if you could help us with your knowledge on thus, it would be great. thank you

[@cjtheodore]

Amazing video. Simple and incredibly intuitive.

[@MuneeswaranSaravanakumar]

Then where is thermal management

[@DakshinaRaghu]

Great video! :)

[@roshandeshmukh9818]

Hello sir please make playlist 👍

[@nomanshiekh26]

Very Helpful 👍

[@rishabhkumar7503]

very nice and informative

[@sudhakarv2823]

Sir please explain about DCDC/ESC converter.

[@awan2344]

Very informative

[@HamdyAmry]

what is this SOE ?

[@mohamedibrahim6226]

Safe operating envelope

[@Assad.Ashi_1]

Nice information Thanks

[@annonymousvector1690]

Thanks for the video. Great stuff

[@ranjitmangaraj7924]

Sir, great Explained. Please post some video regarding Battery Testing in lab with power Anzylr .. and with some software

[@이현익-j1s]

great vedio. TYVM.

[@danielchen9841]

u create grate vid .thank u very much

[@LalthlenglianaKhawlhring]

Thank you 💐

[@msb9582]

Thanks a lot

[@ciurdarandrei6311]

One video is equivalent to 6 months of university courses :)

[@poginani7951]

you mean to say monitoring the cell or battery if its charging the wire for cell b1 b2 b3 just monitoring only not charging the charging come from negative and positive and the other 3 wire b1b2 b3 just monitoring the voltage when charging

[@manojsaravana3877]

Thank you

[@bra1nsen]

Thank you

[@cadillacescalade1]

Fair enough 👍👍👍👍👍

[@fehmighrairi5467]

i wanna work in your company please

[@MikeJrOfficial]

Tom Cruise little brother?? haha, good video.

[@al-ayoungentstailorfasalia651]

Thanks

[@WiSeNhEiMeR-1369]

Howdy S-S, ... any RECOMMENDATIONS for a 48 Volt BMS brand Name ? I run a 36 PV panel system, in a 6S / 6P configuration 230 volt "DC" input ALL-IN-ONE 120 / 240 volt "AC" GROWATT Inverter SPF 6000T DVM-MPV I would like to BUILD my own Battery Bank ... Thanks, COOP the WiSeNhEiMeR from Richmond, INDIANA ...

[@paulwyleciol3459]

thanks!

[@Karncagibiolagradmlarlailerle]

Harikasın sayende rc arabamdaki sorunu çözdüm

[@EricPham-ui6bt]

thanks 😅

[@tyt6877]

Justin Trudeau teaching BMS, nice.

[@رسمينوفل]

Nice

[@ashujoshi1632]

useful

[@SDILUYNTsiu39fnd]

this isn't beatmania...