When Cutting Issues Cause End Seal Leakers on Horizontal Flow Wrappers

[@rajkumarmahata8278]

What is the solution for continue product in seal leakage during running machine. 200 ppm. Parameters Setting , lug chain , belts all are adjusted , but still problem presist

[@greenercorporation]

Thanks for your comment! If you would like to consult with one of our technical support staff about your sealing problem, please send us a message via the Contact page on our website, greenercorp.com/about/contact or email us directly at [e-mail] We will be happy to assist you.

[@gokmachine]

Always beware when adjusting an already used serrated knife. Do not to displace it left or right in the slot of the crimper. When adjusting with shims mark it on one side to prevent accidental turning.

[@greenercorporation]

Thank you for your adding this very good point. We teach this concept in our training programs, and probably should have included it in our post and video.

[@engineer567]

What is the radius of the jaws at the cutting end

[@greenercorporation]

Thanks for your comment. The overall radius on the sealing face of the jaws should be half of the distance between the centerlines of the upper and lower shaft. This dimension can be different depending on the manufacturer and model of the flow wrapper. I hope that this answers you question, but if not please send us a message via the Contact page on our website, greenercorp.com/about/contact or email us directly at: [e-mail] We will be happy to assist you.

[@engineer567]

@@greenercorporation could you please provide a handsketch for explaining

[@greenercorporation]

@@engineer567 I am not certain exactly which radius you are trying to determine. Please send your question on the contact from from Greener Corporation's website, greenercorp.com/about/contact and one of our technical staff can assist you. Thank you.

[@manoharmoni4665]

Thts grt