When to Use Average Values When to Use RMS Values for Power Calculations

In this video, Dr Ali Shirsavar from Biricha Digital explains when we should use Average values and when we should use RMS values in our power calculations and why.

[@lrdisco2005]

Excellent explanation from someone who completely understands how to teach.

[@enesyuce0]

I learn many things about power electronic in this channel. Everything is well defined

[@mohang5931]

Very well explained.

[@nirajrsharma]

Very nice explanation!!

[@archie6586]

Another explaination can be that all periodic waveforms can be considered as a sum of different sinusoidal frequecies( Fourier series). When we multiply voltage and current for power only the components with same frequency will produce power. Hence if a power loss is to be calculated across diode, the voltage across diode is a dc, but for current it is ac ( with multiple frequencies) but only the dc or avg term will result in power loss. Similarly for mosfet both the quantities are ac, so rms is used represent the whole ac quantity quantity

[@osamahebala6923]

Nice explanation

[@BIGRIP87]

nice.

[@paulpaulzadeh6172]

Could you please make how to calculate for fuse too , it not so easy .🤲🤲

[@shekar9237]

Excellent

[@narendra6153]

Thnx for the video!! Please make a video on calculation for NTC selection as a current limiter..

[@AbhishekSharma120]

Yes thats what they teach in college about the diode forward drop, but in real world the forward voltage drop across a diode is NOT constant, it increases with the current flowing through it. Simply pickup any datasheet of a diode and check for Vf vs I characteristics

[@bellomuhammed4047]

Please, what will multimeter in DC and AC mode measured when hooked up to AC supply. Came at right while am thinking about the difference between RMS and AVR value.

[@robegatt]

Since you are calculating the areas under the signals, if the signal is always positive the value rms and avg are the same. If the signal goes negative it subtracts from the avg and it sums for the rms. That is why rms is useful for power measurements (power is always positive). In the particular case of sinusoidal signals you can easily calculate rms from peak value just dividing by sqrt(2)... (btw in this case the avg is zero). For DC avg and rms are the same.n

[@fala-at]

Dear Dr, I don't understand the move to RMS values at this point kzbin.info/www/bejne/gGezkoyMatRmbLc. Could you give me some tips ?

[@aimiliosdraginis3178]

worst explanation ever, he proved the formula in the rms case using the formula itself xd!

[@federicogemin1715]

Nice explanation